Operation Manual

INSTALLATION INSTRUCTIONS

Freestanding Outdoor Grill Installation

Unpack Grill

1. Remove all packaging materials and remove grill from the

shipping base.

2. Move grill close to desired outdoor location.

3. Open the grill hood.

Remove Packaging Material Inside the Grill

1. Use a utility knife to cut yellow straps and packing tape to

open box from top and remove the boxes.

2. Remove the warming shelf and grill grates from inside the grill

and remove the package inside the firebox.

3. Remove foam block and wrap from inside the grill.

Attach Right Side Shelf with Sear Burner

1. Unpack right side shelf with sear burner.

2. Open grill lid.

3. Remove 3 screws from the side of the searing side burner.

4. Remove the screws from the central post, then 2 screws on

the grill side panel and 1 screw on the grill control panel.

5. Lower the side shelf so that the center post (A) slides into the

bracket (B) and align the bottom keyhole slots on the side

shelf with the screw holes on the grill side panel.

IMPORTANT: This step is meant to help with the installation, but

do not depend solely on the bracket to hold the weight of the

sear burner.

6. Attach the top of the side shelf to the grill (A) by inserting the

screws removed in Step 3 into the side shelf from inside the

grill hood and tighten. See illustration in Step 8.

7. Attach the bottom of the side shelf to the side panel (B and C)

of the grill by inserting the 3

screws removed from the grill

side panel in Step

4. The drip pan may need to be pulled

forward to install the center screw (C). Tighten the screws.

See illustration in Step

A. Searing side burner screws

Excessive Weight Hazard

Use two or more people to move and install grill.

WARNING

Failure to do so can result in back or other injury.

A. Grill control panel screw

B. Grill side panel screws