Instructions / Assembly

19
GAS CONVERSION
Tools and Parts for Gas Conversion
Gather the r
equired tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
 Phillips screwdriver  Thin flat-blad
e screwdriver
 Pipe wrench  Pliers
 Adjustable wrench  Pipe thread sealant certified for
LP gas
 6 mm socket and
wrench or 6 mm nut driver
Parts supplied
 Natural gas orifices
Parts needed
 Natural gas conversion kit Part Number 710-0003. See
“Assistance” section to order. The conversion kit includes:
 Natural gas regulator 4" W.C. (marked “Natural Gas
Regulator”)
 10 ft (3.0 m) Natural gas hose with quick connector
 5.9" (150 mm) Natural gas regulator hose
 6 mm nut driver
 6 mm wrench
 Hex key
IMPORTANT: Gas conversions must be done by a qualified
installer. Before proceeding with conversion, shut off the gas
supply to the appliance
.
Conversion from LP Gas to Natural Gas
Installation of the regulator
1. Turn off the main gas supply valve.
2. Disconnect 20 lb LP gas fuel tank (if present).
3. Turn off all burner control valves.
4. Remove the 20 lb LP gas fuel tank (if present) from the grill
cart.
5. Use an
adjustable wrench to remove the LP regulator from the
manifold.
6. Use an
adjustable wrench to install the Natural gas regulator
hose to the manifold and secure. Attach the Natural gas regulator to
the side panel inside the grill cart with the two screws that are
preassembled on the regulator.
Make Gas Connection
1. A combination of pipe fittings must be used to connect the grill to
the existing gas line.
 The 10 ft (3.0 m) PVC flexible gas supply hose design certified by
CSA must be used.
 Pipe-joint compounds suitable for use with Natural gas must be
used. Do not use Teflon®† tape.
 There must be a certified manual shut-off valve in the gas supply
line near the grill for easy access.
2. Connect the brass connector on one end of the 10 ft (3.0 m) PVC
flexible gas supply hose to the Natural gas pressure regulator.
† ®TEFLON is a registered trademark of E. I. Du Pont De Nemours
and Company.
( Pre-installed behind the liquid propane
orifices in the main gas valves)
WARNING
Explosion Hazard
Use a new CSA International approved “outdoor”
gas supply line.
Securely tighten all gas connections.
Failure to do so can result in death, explosion, or fire.
Install a shut-off valve.