Installation Guide

Firebox Assembly
1. Remove the 4 screws under the firebox (A) on each
corner. Place the firebox on the cart as shown with the
hose inside the cart and reattach the 4 screws. Tighten
to secure.
L
A
Note: Make sure the LP regulator hose is placed through
Note: Door may misalign when grill is rolled over uneven
ground or positioned on uneven ground. To adjust door
alignment the hinges need to be adjusted. Loosen the screws
marked A securing the door hinges. Hold door and hinges in
desired position and tighten screws to secure the hinges. To
adjust door angle, turn screws marked B clockwise to move
door left and counterclockwise to move door right
S
Note:
Make
sure
the
LP
regulator
hose
is
placed
through
the gap area of the heat shield and is inside the cart when
attaching firebox assembly.
door
left
and
counterclockwise
to
move
door
right
.
9
L2 hih
bl d h
9
.
L
oosen
2
screws (B)
hi
c
h
are pre-assem
bl
e
d
on t
h
e cart
frame (K) and 2 screws (B) pre-assembled on the heat shield
(F), hang the heat shield between the cart frame and rear
panel of cart by the screws previously loosened, and
tighten screws.
13
F
K
w
B
B
A
A
Remove 1 screw (A) which pre-assembled on the cart frame (K)
and 1 screw (A) which pre-assembled on the heat shield (F);
F
K
8. Remove 8 screws pre-assembled on the door supporting
trim (S), use the 8 screws to attach the door to the cart
by aligning the screw holes on the door hinge (L) with
the screw holes on the door supporting trim (S),
tighten the screws as shown below.