Installation Guide

INSTALLATION INSTRUCTIONS
Freestanding Outdoor Grill Installation
s
Hardware contents pre-installed as noted in instructions
that follow.
REF# Description QTY
1 1/4”*15MM Truss Head Screw 16pcs
2 5/32”*10MM Truss Head Screw 16pcs
3
5/32”*10MM
Countersunk Head screw
12pcs
5.4.3.2.1.
3
5/32”*10MM
Countersunk
Head
screw
12pcs
4 1/4”*12MM Truss Head Screw 14pcs
5 5/32” Flat Washer 2pcs
Preparation
Before beginning assembly, make sure all parts are present.
Compare parts with package contents list and diagram
above. If any part is missing or damaged, do not attempt to
assemble the product. Contact customer service for
replacements parts.
• Estimated Assembly Time: 20 minutes
• Note: The right and left sides of the grill are designated as
if you are facing the front of the grill.
Swivel Caster Assembly
1. Unpack bottom panel and 4 casters. Remove 16
screws pre-assembled on the bottom panel and use
those screws to secure the four casters. Two casters
(H) should assemble on the line of left side, swivel
caster (I) assemble on the front right side, swivel caster
with brake (J) assemble on the rear right side as shown
below.
11
I
J
H
1. Unpack the left side panel (B) , right side panel (C)
and rear panel (D). Loosen 8 screws which are pre-
assembled on the bottom panel and 6 pre
-
Cart Assembly
assembled
on
the
bottom
panel
and
6
pre
-
assembled screws on the left and right side panels.
2. Secure the left side panel (B) by clipping the open
hole onto the screws which are pre-assembled to
the bottom panel and tighten the 3 screws.
Attach the L shape bracket with the bottom panel
1. Loosen 2 screws which are pre-assembled on the
left side of the bottom panel.
2. Secure the L shape bracket by clipping the open
hole onto the screws and tighten 2 screws.
Tank Tray assembly
Remove 4 screws pre-assembled on the bottom panel,
use the 4 screws to attach the tank tray to the bottom
panel, then tighten the screws as shown below