Installation Guide

 Clean the exterior of the burner with a wire brush.
 Clear any clogged burner ports with a
straightened paper clip
 Do not use a toothpick as it may break off and
clog the port
BURNERS
Cleaning Method:
Cleaning Method:
1. Light the rotisserie burner. See the “Using Your Rotisserie
Burner” section.
2. Close the grill hood.
3
Leave the burner on high for approximately 30 minutes
ROTISSERIE BURNERS
clog
the
port
.
 Check and clean burner/venturi tubes.
1. Remove grill grates and flame tamers.
2. Remove the cotter pin that hold the burner in
place. Remove gas burner from the grill.
IMPORTANT: The grease box should only be removed when
grill is completely cool.
The full-width grease box collects grease and food particles
that fall through the grill. Clean often to avoid grease buildup.
Cl i M h d
3
.
Leave
the
burner
on
high
for
approximately
30
minutes
.
4. Turn knob to OFF and let cool completely.
5. Brush off ash particles from the rotisserie burner.
Cl
ean
i
ng
M
et
h
o
d
:
 Remove grease box and set on a flat surface.
 Wipe excess grease with paper towels.
 Mild detergent and warm water. Rinse and dry
thoroughly.
 Replace grease box.
IMPORTANT
Tidd kbfl
KNOBS AND FLANGE AREA AROUND KNOBS
3. Use a flashlight to inspect the burner inlet to ensure there
is no blockage. If any obstruction is seen, use a metal
coat hanger that has been straightened to clear them.
4. After inspecting the inside of burner for blockage,
bl b b lidi th iddl t b f th
IMPORTANT
:
T
o avo
id
d
amage to
k
no
b
s or
fl
ange area
around knobs, do not use steel wool, abrasive cleaners, or
oven cleaner.
Do not soak knobs.
Cleaning Method:
 Mild detergent, a soft cloth and warm water.
 Rinse and dry.
CONTROL PANEL GRAPHICS
reassem
bl
e
b
urner
b
y s
lidi
ng
th
e m
iddl
e
t
u
b
e o
f
th
e gas
burner over the gas orifice.
IMPORTANT: To avoid damage to control panel graphics, do
not use steel wool, abrasive cleaners or oven cleaner.
Do not spray cleaner directly onto panel.
Cleaning Method:
Clean around the burner labels gently; scrubbing may
remove printing.
Mild detergent, soft cloth and warm water.
Rinse and dr
y
.
A
A
Burner/orifice
connection
y
A
.
Burner/orifice
connection
5. Reattach gas burner using screw.
30
A
A
A. Cotter pin