Installation Guide

3. Conne

ct the quick connector on the other end of the

10 ft (3.0 m) PVC flexible gas supply hose to the rigid Natural

gas supply pipe.

Change Grill

Burner Valve Orifices

1. Remove the grates and flame tamers.

2. Remove the 1 screw and cotter clip that hold the burner in

place. Set the screw and clip aside. Remove the burner from

the grill by lifting the burner out.

3. Use a 6 mm socket and wrench or 6 mm nut driver to remove

the brass orifice from the end of gas valve. The main burner

orifice is located behind the LP orifice, so no additional orifice

needs to be installed.

IMPORTANT: Check that the orifice is properly installed

inside of the burner opening.

4. Reinsert the burner and reattach using the 2 screws

previously removed. Repeat the procedure for each main

burner.

5. Position the igniters so they are ¼" (6.0 mm) away from each

burner.

Left side panel

B. Manifold

C. 10 ft. (3.0 m) PVC gas hose

D. Natural gas pressure regulator/hose assembly

A. Screw

B. Cotter clip

Main burner orifice