Dishwasher Installation Instructions

(I r ! I'1
Connectdrainhoseto an air gaporwasteteeusing one of the
recommendedor alternatemethods.
Recommended Connection Methods
Install Air Gap Kit (Part No. 300096) (A) according to kit
instructions. If a different air gap is used, it should be checked to
make sure it allows for the same air flow.
Drain hose (B) to air gap (A) to waste tee (C)
Cutdrain cod of drain hose as shown (D). Do Notcut ribbed
sectionto shortendrainhose (E).
,t,
Securedrainhose toairgapwithspring-typeclamp(F). If
spring-typeclampdoesnotfit smallersection of drainhose
connector,use a smallerclamp. Smallerclampsareavailableat
plumbingsupplystores.
Connectthe airgap towastetee usinga rubberconnector(G)*
and spring-orscrew-typodamps (H).
The waste tee connection MUSTbe ahead of the drain
trap (I) and 20 inches (50.8om) minimum above the
floor O).
Drain hose (K) to air gap (L) to disposer (M)
Knock out disposer inlet plug (N) from inlet. Ifinletplug
fallsinside disposer,youmust removeinletplugbefore
connectingdrainhose. Ifdisposeris alreadyinstalledin sink,
you may needto removedisposerfromsinkto removeplug.
DONOTcutendof drainhose.
Securedrain hose to air gapwithspring-typeclamp(0).
Connectthe airgapto disposer using a rubberconnector (P)*
andspring- or serew-typoclamps(Q).
Mostdisposershave7/8"connectors,or specia]connectorsare
availableatplumbingsupplystores.
The disposer connection MUSTbe ahead of the drain
trap (It) and 20 inches (50.8cm) minimum above the
floor (S).
* All parts are available from your dealer.