INTEGRATED COMPACTOR Use & Care Guide For questions about features, operation/performance, parts, accessories or service, call: 1-800-422-1230 or visit our website at www.kitchenaid.com In Canada, for assistance, installation or service, call: 1-800-807-6777 or visit our website at www.KitchenAid.ca Table of Contents............................................................................................................
TABLE OF CONTENTS COMPACTOR SAFETY ..................................................................2 INSTALLATION INSTRUCTIONS ..................................................3 Unpacking ....................................................................................3 Location Requirements ................................................................4 Electrical Requirements ...............................................................5 Undercounter Installation.................................
IMPORTANT SAFETY INSTRUCTIONS WARNING: When using an electrical appliance, basic precautions should always be followed, including the following: ■ Read all instructions before using the compactor. ■ Close supervision is necessary when used by or near children. Do not allow to be used as a toy, or to run unattended at any time. Lock Key Switch when not in use and store key out of reach of children. Do not touch moving parts.
. Place the other 2 corner posts on the floor to the side of the compactor. Grasp the sides of the compactor cabinet and put compactor on its side on top of the corner posts. Remove the shipping base from the bottom of the compactor. A Cutout Dimensions B 3" min. (7.6 cm) A 34¹⁄₄" min. (87 cm) A. Leveling legs B. Shipping base 24" min. (61 cm) 18" min. (45.7 cm) Location Requirements Product Dimensions 15¹⁄₄" min. (38.7 cm) A. Grounded eletrical outlet must be a minimum of 3" (7.
Electrical Requirements WARNING Undercounter Installation NOTE: Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the personal responsibility and obligation of the customer to contact a qualified installer to assure that electrical installation meets all National and Local codes and ordinances. Tools needed: Gather the required tools and parts before starting installation. Electrical Shock Hazard ■ Level ■ Phillips No.
2. Use pliers to lower leveling legs away from cabinet. Adjust legs so there will be a ¹⁄₈" (3 mm) to ¹ ₄" (6.4 mm) space between the top of the compactor and the top of the cabinet opening. Stand the compactor upright. 3. For model with cabinet, remove the plastic plugs from the compactor cabinet top. 4. Move the compactor close to its final position. 5. Plug into a grounded 3 prong outlet. 6. Determine if you want the compactor frame or drawer front flush with the cabinet front.
3. Secure the custom panel to the exterior drawer front by using four #8 x 1" wood screws from the inside drawer front. ■ Install the top 2 wood screws as shown. ■ Use the bottom 2 wood screws to also re-install the 2 rubber bumpers on each side of the lower inside drawer while attaching to the custom panel. Load bulky trash, bottles, and cans in the center of the drawer. Bottles or cans not placed in the center may become caught between the ram and the drawer.
Starting Your Compactor 1. 2. 3. 4. 5. Open container. Load trash. Leave Key-Knob in ON position. Set Solid Cycle switch to OFF. Close container. Lift foot pedal UP to START cycle. Using Solid (Locked) Cycle The Solid (Locked) Cycle extends the use of the bag by putting constant pressure on the trash to keep it from springing back. Regular use of solid cycle can increase bag capacity up to 25 percent. During Solid Cycle, the ram will stay in the down position for extra compacting.
3. Press inside of bag against the drawer bottom, sides and corners for a smooth fit. Cleaning Exterior Surfaces 1. Wash exterior surfaces (including stainless steel) with a clean sponge or soft cloth and a mild detergent in warm water. Do not use abrasive or harsh cleaners. Rinse and dry thoroughly with a soft cloth. 2. Wipe up spills right away. Some foods can damage the finish if left on the compactor surface.
3. Grasp the drawer on the sides and pull it out the rest of the way. Set the drawer down gently. Cleaning the Ram NOTE: You may want to wear protective gloves since there may be bits of glass on the ram cover. 1. Wipe glass particles off of the ram cover with a cloth or paper towels. 2. Remove foods with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth. 4. Vacuum the inside of the cabinet.
ASSISTANCE OR SERVICE Before calling for assistance or service, please check “Troubleshooting.” It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance. This information will help us to better respond to your request. If you need replacement parts If you need to order replacement parts, we recommend that you use only factory specified parts.
KITCHENAID® COMPACTOR WARRANTY ONE YEAR LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, KitchenAid or KitchenAid Canada (hereafter “KitchenAid”) will pay for factory specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a KitchenAid designated service company.
