Precautions and general recommendations 4 Reference guide 6 Options and display description 7 First time use 8 Daily check 9 Daily use 11 How to load the racks 12 Maintenance and care 14 What to do if...
Precautions and general recommendations 1. Packing The packaging materials are 100% recyclable and marked with the recycling symbol . 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. 3. Before using the dishwasher for the first time - The appliance is designed to operate with a minimum ambient temperature of 5°C.
- The appliance is not intended to be used without decorative plate. Please ensure that appliance after instalation always have decorative plate. - Use special glows at the assembling of appliance. - During use, the access to the rear wall should be limited in a sustainable manner such as approaching the device to the wall or furniture board. - Keep packaging materials out of the reach of children. - Children must not be allowed to play with the appliance.
Reference guide 1. PROGRAMS SELECTION BUTTON Push “P” button (repeatedly) until selected program number is shown on the display (P1...Px) see “Table of programs” below. 2. CANCEL/OFF BUTTON Push this button to switch off the control panel. If pressed when a program is running it cancels the program ongoing draining water for 1 minute (0:01 is shown into the display). If pressed when the dishwasher is switched off, it drains any possible liquids from dishwasher (1 minute process). 3.
Options and display description BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS! THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. 4. TABLET SETTING This setting allows to optimize the cycle performances according the type of detergent used.
First time use 1. salt reservoir 2. rinse aid dispenser 3. detergent dispenser 4. racks system 5, 6, 7, 8. available functions on the panel 9. filters 10. spray arms How to set water hardness in order to always assure the best cleaning results Water hardness should be set only before the first wash or if water hardness has been changed. - Press and hold together Program and buttons for minimum 3 seconds. - The current water hardness setting will be visible on the display.
Daily check Once regeneration salt is added, immediately start a wash program (the “Pre-wash” program alone is not sufficient). Residual saline solution or grains of salt can lead to deep-down corrosion, irreparably damaging the stainless steel components. The guarantee is not applicable if faults are caused by such circumstances.
Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator Check the rinse aid indicator to check the level into the dispenser. (depending on the model) Visual Visual indicator indicator Rinse aid indicator on the control panel The indicator lamp lights up when RINSE AID NEEDS TO BE ADDED. Rinse aid indicator on the dispenser dark OK. If required, open the cover B (press the dedicated button).
Daily use Use only one tablet per one cycle, only placed in detergent dispenser. Adding detergent Use only detergent specifically for dishwashers in accordance with the supplier’s recommendations Some type of tablets could not dissolve completely during the short programs (Rapid, Fragile, Handwash); placing the tablet on the tub bottom can help dissolving and washing. Shut the cover by pressing dedicated ribs. Open the cover A (press the dedicated button).
How to load the racks UPPER RACK - depending on the model How to adjust upper rack height (if available). It could be useful to lift up the upper rack to have more space in lower rack or bring it down to load long stem glasses. - Grasp and take out the two lateral handles (C) (they must be on the same level) and lift up or take down the upper rack. A - Adjustable flaps (2 or 4): in horizontal position for cups/long utensils/stemmed glasses. Rotate the flap clockwise and hook on rack.
LOWER RACK - depending on the model E - Cutlery Basket. F - Grid: helps to keep the cutlery separate for better washing results. G - Vertical plate holders: they can be folded down to load pot. H - Lateral support with foldable flaps (if available): shelves can be used to hold long tools or cups onto. F E THE LATERAL SUPPORT CAN BE REMOVED: Pull the supportto the front of the basket and lift to remove it.
2 1 Switching off the appliance. Everything OK... 3 After the program is completed appliance turns into Standby mode automatically. All indicator lamps switch off. Exercise caution when opening the door: beware of hot steam. Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. To change the program in progress: - Press the CANCEL/Off button to cancel the program on running.
Rectifying minor faults yourself... Spray arms Remove blockages/deposits. 2 1 Unscrew and remove upper arm... Clean spray nozzles under running water (use toothpicks if necessary)... 4 3 5 6 Insert and screw on upper and lower arms tightly. Unscrew and remove lower arm...
What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance... Possible causes... Solutions... salt indicator is lit • Salt reservoir is empty. (After refill the salt indicator may remain lit at the end of several wash cycles). • Refill reservoir with salt. • Adjust water hardness.
After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated. RESET: - Press the Cancel/Off button. - Close the door. - Water drains automatically for up to 1 minute. - The appliance is now ready to be restarted. Crockery and cutlery... ...are not perfectly clean/have food residues ...have deposits: regeneration salt residue ...are not dry Possible causes... Solutions...
Crockery and cutlery... Possible causes... Solutions... ...have discoloured plastic parts • Tomato/Carrot juice. • Tomato sauce, for example, can lead to discolouring of plastic parts. Powder detergent is recommended as it allows slightly higher doses to be used for improved whitening. Programs with higher wash temperatures should be used. ...opaque glasses, etc. • Dishes unsuitable for washing in dishwashers (porcelain). • Only use dishwasher-proof crockery and dishes. ...
Disconnect the mains plug If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the After-sales Service (see warranty).