nnnnnnnnnnnnnnnnnnnnnnnnnnn nnnnnnnnnnnnnnnnnnnnnnnnnnn mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm mm nnnnnnnnnnnnnnnnnnnnnnnnnnn nnnnnnnnnnnnnnnnnnnnnnnnnnn KitchenAPd.
1 Befotw you begin Read these instructions completely and carefully. If followed, they will simplify the installation job. IMPORTANT: Observe all governing codes and ordinances. Failure to follow these instructions could lead to fire or electrical shock hazard. A. Space requirements A = 30” min. clearance between cooktop and bottom of an unprotected wood or metal cabinet. B = Ei;l;h,Wween counters: 303/8” 1 '1 C = Height of countertop: 355A3”to 36’3/16” AB- I v -L---___ I C tEE + 20 7” Max.
B. Electrical requirements l l WARNING: DO NOT PLUG THE “PIGTAIL’ POWER CORD INTO A LIVE WALL RECEPTACLE BEFORE CORD IS PERMANENTLY CONNECTED TO THE TERMINAL BLOCK. 1 This appliance must be connected to the proper electrical voltage and frequency as specified on nameplate. A separate 40 ampere circuit is required. Fuse both sides of the line. DO NOT fuse the neutral. A time-delay fuse or circuit breaker is recommended.
2 Begin the imtallation Remove racks and all other contents from oven before moving appliance. Be sure to remove all packaging material (cardboard, protective film, etc.) from range before use. A.
B. Strain relief required Use this wiring method ONLY if local codes permit connecting frame grounding conductor to neutral wire of power cord. Clamping THIS APPLIANCE IS MANUFACTURED WITH NEUTRAL TERMINAL CONNECTED TO THE FRAME. 1. Connect neutral wire to the center silver-colored terminal. 2. Connect remaining 2 wires to the terminals either side of the silver-colored terminals. 3. Use ring type terminals only. Connect with the brass nuts that are taped to the frame.
Level andposition the range Spirit level 7 C. Complete electrical connection Remove oven utility drawer. Reach to the rear of the appliance and plug flexible pigtail into the approved receptacle (if allowed by local codes). OR Connect flexible armored or non-metallic shielded cable directly to fused disconnect box. 5 A. Leveling Move range into final operating position. Use caution when moving this appliance to prevent damage to floor coverings.
D. Clock Refer to operating instructions in the Use and Care Guide (packed in utility drawer). E. Cleaning See the Use and Care Guide that was packed in the utility drawer for proper care and cleaning instructions. 6 Before you calI for sewice... See the Use and Care Guide for trouble-shooting checklist. Be sure pigtail power cord is plugged in. Check for blown fuses or tripped circuit breaker. If you must call for service... You will need the appliance model and serial number.
3-87 Part No. 3147379 Rev. A KitchenAid.” Inc. St. Joseph, MI 49085 Printed in U.S.A.
