Installation Guide

2
Important Safety Information
Recognize Safety Symbols, Words, Labels
DANGER!
DANGER—Immediate hazards which WILL result in severe personal injury or
death.
WARNING
!
WARNING—Hazards or unsafe practices which COULD result in severe personal
injury or death.
CAUTION
!
CAUTION—Hazards or unsafe practices which COULD result in minor personal
injury or product or property damage.
What You Need to Know about
Safety Instructions
Warning and Important Safety Instructions
appearing in this manual are not meant to
cover all possible conditions and situations
that may occur. Common sense, caution, and
care must be exercised when installing,
maintaining, or operating refrigerator.
Read entire manual before installing kit. All
necessary tools and materials must be
available prior to installation. Verify all listed
parts are included in kit. If parts are missing,
contact source from whom kit was purchased.
• If unable to solve a problem during
installation, refer to your refrigerators
owners manual for service information.
Before Calling Service...
If something seems unusual, please check
“Trouble Shooting” section, which is
designed to help you solve problems before
calling service.
WARNING!
To avoid electrical shock which can cause severe personal injury or death, follow
basic precautions, including the following:
• Unplug power cord or open household circuit breaker to refrigerator before installing kit. After
installing kit, reconnect power.
CAUTION!
To avoid risk of personal injury or property damage, follow basic precautions,
including the following:
• Do not place fingers or hands on or around the automatic icemaking mechanism while the refrig-
erator is plugged in.
• REPLACE ORIGINAL ICE STORAGE BUCKET WITH ONE FROM KIT to avoid spilling ice cubes.
• Confirm water pressure to water valve is between 20 and 100 pounds per square inch. If water
filter is installed, water pressure to water valve must be a minimum of 35 pounds per square inch.
• Start nuts by hand to avoid cross threading. Finish tightening nuts using a wrench. Do not over-
tighten.
• Check carefully for water leaks prior to returning refrigerator to normal location and 24 hours after
connection.