Installation Instructions

6
Location Requirements
The refrigerator can be recessed in an opening between cabinets
or installed at the end of a cabinet run using a side panel to
enclose the refrigerator.
IMPORTANT: This appliance is intended to be used in household
and similar applications such as:
■ Staff kitchen areas in shops, ofces and other working
environments.
■ Farm houses and by clients in hotels, motels and other
residential type environments.
■ Bed and breakfast type environments.
■ Catering and similar non-retail applications.
■ Observe all governing codes and ordinances.
■ It is recommended that you do not install the refrigerator near
an oven, radiator, or other heat source.
■ Do not install in a location where the temperature will fall
below 13°C (55°F).
■ Floor must support the refrigerator weight, more than 600 lbs
(272 kg), door panels and contents of the refrigerator.
■ Ceiling height must allow for side tipping radius. See “Tipping
Radius.”
■ Location should permit door to open fully. See “Door Swing
Dimensions.”
■ Location must permit top grille removal. See “Opening
Dimensions.”
Opening Dimensions
■ To avoid tipping during use, the solid soft must be within
1" (2.5 cm) maximum above the refrigerator. If the solid soft
is higher than 1" (2.5 cm) or one is not available, then the
refrigerator must be braced.
If anti-tip boards are needed, they must be installed to the
rear wall studs so that the bottom of the anti-tip board is
84" (213.4 cm) from the oor. See “Install Anti-Tip Boards” for
more information.
NOTES:
■ A clearance of 1/2" (1.3 cm) must be maintained above
the top grille in order for the top grille to be removed.
■ Do not remove the foam gasket on top of the compressor
cover unless removal is necessary to t the unit under a
soft. Removal of the gasket will cause loss in cooling
efciency.
■ If installing under a solid soft, after, installation raise the
leveling legs so that the gasket is pressed snugly against
the soft.
■ A grounded 3 prong electrical outlet should be placed within
4" (10.2 cm) of the right side cabinets or end panel. See
“Electrical Requirements” for additional information.
■ The water shutoff should be located in the base cabinet on
either side of the refrigerator or some other easily accessible
area. If the water shutoff valve is not in the cabinets, the
plumbing for the water line can come through the oor or the
back wall. See “Water Supply Requirements” for more specic
information.
Model Width A
(as shown above)
Dimension B
(as shown above)
36" 35½" to 35¾"
(90.2 cm to 90.8 cm)
4" (10.2 cm)
42" 41½" to 41¾"
(105.4 cm to 106 cm)
7½" (19 cm)
NOTE: Flooring under refrigerator must be at same level as the
room.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
B
A
A. Gasket
B. Compressor cover
B
1/2"
(1.3 cm)
A
Dimension
77"
(196 cm)
6"
(15.2 cm)
6"
(15.2 cm)
6"
(15.2 cm)
1"
(2.54 cm)
24"
(60.96 cm) min.
Width
(see chart following)
84" (213.4 cm)
to bottom of solid soffit