Dimensions Guide

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10721177A
12/4/14
OPENING DIMENSIONS
To avoid tipping during use, the solid soffit must be within 1" (2.5 cm) maximum
above the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or one is not
available, then the refrigerator must be braced.
If anti-tip boards are needed, they must be installed to the rear wall studs so that the
bottom of the anti-tip board is 84" (213.4 cm) from the floor.
NOTE: Do not remove the foam gasket on top of the compressor cover unless
removal is necessary to fit the unit under a soffit. Removal of the gasket will cause
loss in cooling efficiency.
A. Gasket
B. Compressor cover
¹⁄₂"
(1.3 cm)
B
A
NOTE: If installing under a solid soffit, after installation raise the leveling legs so that
the gasket is pressed snugly against the soffit.
6"
(15.2 cm)
84" (213.4 cm)
to bottom of solid soffit
24"
(60.96 cm) min.
1"
(2.54 cm)
77"
(196 cm)
6"
(15.2 cm)
6"
(15.2 cm)
A
Width
(see chart following)
Model Width A
NOTE:
A clearance of
¹⁄₂"
(1.3 cm) must be
maintained above
the top grille in
order for the top
grille to be removed.
NOTE:
Flooring under
refrigerator must
be at same level
as the room.
B
Model Dimension B
36" (91.4 cm) 4" (10.2 cm)
42" (106.7cm) 7¹⁄₂" (19 cm)
36" 35¹⁄₂" - 35³⁄₄"
(91.4 cm) (90.2 cm - 90.8 cm)
35
³⁄₄" - 36"
Overlay (90.8 cm - 91.4 cm)
42" 41¹⁄₂" - 41³⁄₄"
(106.7 cm) (105.4 cm - 106.0 cm)
41
³⁄₄" - 42"
Overlay (106.0 cm - 106.7 cm)
TIPPING RADIUS
Be sure there is adequate ceiling height to stand the refrigerator upright when it is
moved into place.
■
The dolly wheel height must be added to the tipping radius when a dolly is used.
■
If needed, the tipping radius can be reduced. See “Reduce Tipping Radius.”
Side Tipping Radius (36" [91.4 cm] Models)
A. Tip this side only.
90¹⁄₂"
(229.9 cm)
A
Side Tipping Radius (42" [106.7 cm] Models)
A. Tip this side onl
y
.
93"
(236.2 cm)
A
Page 2 of 2