Installation Instructions

10
36" (91.4 cm) French Door Models 42" (106.7 cm) French Door Models
Overlay Series Custom Panels
Custom overlay panels allow you to blend the exterior of your
refrigerator into the overall kitchen decor and to use custom
handles for additional design exibility.
The custom panels must have backer panels attached in order to
mount them to the refrigerator. It is most common to work with
three panels, as shown in the following graphic: a decorative
overlay panel, a 1/8" (3.18 mm) spacer panel or spacer strips and
a 1/4" (6.35 mm) backer panel.
In some cases, your cabinet manufacturer may choose to work
with one panel routed for the different dimensions. Follow these
panel dimension and placement instructions to be sure that the
custom overlay panels will t properly.
IMPORTANT:
■ For 36" (91.4 cm) single-door models, the refrigerator door
overlay panel cannot exceed 50 lbs (23 kg) and the freezer
drawer overlay panel cannot exceed 20 lbs (9.1 kg).
■ For 36" (91.4 cm) and 42" (106.7 cm) French-door models, the
refrigerator door overlay panel cannot exceed 30 lbs (13.5 kg)
and the freezer drawer overlay panel cannot exceed 25 lbs
(11.4 kg).
■ The weight of the top grille overlay panel cannot exceed
10 lbs (4.5 kg) for both models.
To minimize panel weight, you may use 2" (5.08 cm) spacer strips
around the perimeter in place of full-sheet solid spacer panels.
The spacer strips must be set in at least 1" (2.54 cm) from the
top, bottom and side edges of the backer panel. If you use spacer
strips, it is also recommended that you use two 2" (5.08 cm)
strips horizontally centered for added support.
110˚
90˚
110˚
90˚
110˚
90˚
110˚
90˚
39
3
/4"
(101 cm)
41"
(104 cm)
(6.35 mm)
(3.18 mm)
(3.18 mm)
1" minimum
(2.54 cm)
(15.88 to
19.05 mm)
Backer
Panel
5/8" to 3/4"
1/8"
1/8"
1/4"
Spacer Panel
Spacer Panel
Overlay Panel
Overlay Panel
Door/Grille Trim
Backer Panel
Offset Dimension
42
3
/4"
(108.6 cm)
44
1
/4"
(112.3 cm)