Installation guide

Electrical connection
Electrical Shock Hazard
Turn power supply off before connecting wires.
Use 8 gauge solid copper wire.
Ebctrically ground oven.
Failure tofollowthese instructions can result
in death, fire, orelectrical shock.
Thisoven is manufactured with white
(neutral} power supply wire and a cabinet-
connected bare grounding wire twisted
together.
Make electrical connection following
u the steps needed for your installation.
1. Disconnect the power suppJy.
2, Remove the junction box cover.
3. Connect oven cable to junction box
through the U,L,-listed conduit connector,
4. Connect the two black wires together with
twist-on connectors.
5. Connect the two red wires together with
twist-on connectors.
& Complete electrical connection according
to local codes and ordinances,
ff local codes DO NOT PERMIT
connecting cabinet-grounding
conductor to neutral white
wire in junction box:
(Four=wire electrical system)
7. Separate the factory-crimped bare and
white oven cane wires.
8. Connect white oven cable wire to neutral
(white) wire in junction box. See Figure 1.
9. Connect the bare grounding oven cable
wire to the ground wire in the junction
box. Do Not connect bare grounding wire
to neutra_ (white) wire in iunction box.
See Figure 1.
10. Replace junction box cover.
cabb from
power supply
black
wires
white and bare
grounding oven cabte
wires -- factory crimped
U,L=listed conduit
connector
.,_;_ure 2 cable from
microwave oven
if local codes PERMIT
connecting cabinet-grounding
conductor to neutral white
wire in junction box:
(Three-wire electrical system)
7. Connec;t the factory-crimped bare and
white oven cable wires to the neutral
(whitet wire in junction box. See
Figure 2,
8. Replace junction box cover,
Check operation
g m Turn on power supply. The display
panel will light up briefly. "PF" should appear
in the temperature display.
m Cheek the operation of the
microwave oven.
, Fill a microwave-safe container with one cup
of water and place container inside
microwave oven. Close door firmly.
• Set microwave oven cool<time to "2:00"
minutes.
, Pressthe "START/ENTER" pad. The interior
microwave oven light should be on and the
remaining cooking time should be displayed.
• When display reads "1:00," open microwave
oven door. The microwave should stop
cooking.
• Close door firmly. The interior microwave
oven light should turn off.
, Pressthe "START/ENTER" pad. Microwave
oven should begin cooking and the
microwave oven interior light should be on.
, Let microwave oven complete cooking time.
A tone wiii sound four times at end of
cooking time and microwave oven will shut
off.
, Open microwave oven door and carefully
remove container. Water in container should
be hot.
Page 3