Installation guide
D
E
F
A. Cable from home power supply
B. Junction box
C. Black wires
D. White wires
E. Green (or bare) ground wire
(from microwave oven)
F. 4-wire flexible cable from
microwave oven
G. Red wires
H. UL listed wire connectors
I. UL listed or CSA approved
conduit connector
1. Connect the 2 black wires (C) together using a UL listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the microwave oven cable) using a UL listed wire
connector.
3. Connect the 2 red wires (G) together using a UL listed wire
connector.
4. Install junction box cover.
2.
3.
A. Two screws
4. Replace oven racks, turntable and support hub.
5. Reconnect power.
6. Display panel will light briefly, and "PF" should appear in the
display.
7. If display panel does not light, please reference the
"Assistance or Service" section of the Use and Care Guide or
contact the dealer from whom you purchased your
microwave oven.
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For microwave oven use and cleaning, read the Use and Care
Guide.
Check Operation of Microwave Oven
1. Turn power on.
2. When "CLOCK ENTER TIME" appears in the display, press
START/ADD A MINUTE.
Using 2 or more people, lift microwave oven partially into
cabinet cutout.
NOTE: Push against seal area of microwave oven front frame 4.
when pushing microwave oven into cabinet. Do not push
against outside edges.
Push against the front of the microwave oven to push oven
into cabinet. Push microwave oven completely into cabinet
and center in cabinet cutout.
Securely fasten microwave oven to cabinet using the 2 screws
provided. Insert the screws through holes in mounting rails.
Do not overtighten screws.
Fill a microwave-safe container with 1 cup (250 mL) of water
and place container inside microwave oven on the turntable.
Close door firmly.
Touch START/ADD A MINUTE twice to set cooking time to
"2:00" minutes. Microwave should begin cooking, interior
light should be on, and the display should count down the
remaining time.
If microwave does not operate, check the following:
• Household fuse is intact and tight; or circuit breaker has
not tripped.
• Electrical supply is connected;
• See "Troubleshooting" section in the Use and Care Guide.
• If an error code ("F" followed by a number plus "E"
followed by a number) appears in the display, turn off the
microwave oven and contact a qualified technician.
When the display reads "1:00" minute, open the microwave
oven door. The microwave oven should stop cooking. Close
door firmly. The interior microwave oven light should turn off.
5.
Press START/ADD A MINUTE to resume preset cycle.
Microwave should begin cooking, and the microwave oven
interior light should be on.
Let microwave oven complete cooking time. A tone will
sound 3 times at the end of the cooking time.
6. Open microwave oven door and slowly remove container.
Water in container should be hot.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in microwave oven.