Manual

INSTALLATION INSTRUCTIONS
....._ __ _ U¸_ _ ,_ _F_,_I _¸_ ._'*,__-_ ......
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
1. Positionthetanktrayfor20 IbLP gas fueltank intheisland
cabinetand determinethe dimensionforyourgrillsizefrom
thechart.
Unpack grill. Remove all packaging materials and remove grill
from carton.
Place grill into outdoor enclosure, but leave enough room in
back to connect to gas supply and electrical single prong
plug-in.
• Open the hood.
Remove Packaging Material Inside the Grill
1. Cut the tiedowns holding the grates together.
2. Remove warming shelf and grill grates from inside the grill
and remove packaging material.
3. Remove foam block and wrap from inside the grill.
A
// : --
2V4"
(5.7 crn)
205/8"
(52.4 crn)
A
B
Built-In Grill Size Dimension A Dimension B
27" (68.6 cm) 33/8"(8.6 cm) 25V8" (63.8 cm)
36" (91.4 cm) 4" (10.2 cm) 34V8" (86.7 cm)
48" (121.9 cm) 4" (10.2 cm) 46V8" (117.2 cm)
2. Square the tank tray mounting brackets and mark the
mounting hole locations in the island base.
3. Remove the top nuts (4) from the tank tray assembly and lift
the tank tray off of the mounting brackets.
A. Foam block
B. Foam wrap
4. Replace the grill grates.
5. Place warming shelf on brackets as shown.
B
A. Top nut
B. Tank tray
C. Bottom nut
D. Bolt
E. Mounting bracket
A. Warming shelf brackets
B. Warming shelf
6. Dispose of/recycle all packaging material.
14