Manual
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
20 Ib LP Gas Models Natural Gas Models
Tools Needed
• Tape measure • Wrench or pliers
• Small, flat-blade screwdriver • Pipe wrench
• Flat-blade screwdriver • Scissors or cutting pliers
• #2 and #3 Phillips screwdriver (to remove tiedowns)
• Level • Noncorrosive leak-
detection solution
Tools Needed
• Tape measure • Wrench or pliers
• Small, flat-blade screwdriver • Pipe wrench
• Flat-blade screwdriver • Scissors or cutting pliers
• #2 and #3 Phillips screwdriver (to remove tiedowns)
• Level • Noncorrosive leak-
detection solution
Parts Supplied
• Gas pressure regulator/hose assembly set for 11" WCP LP
gas (attached to manifold).
• Rotisserie motor mounting bracket
• Rotisserie motor
• Rotisserie forks
• Rotisserie spit
• Smoker box
• 1 single-prong plug/500 mAmp transformer assembly for the
rotisserie motor
• 1 single-prong plug/5,000 mAmp transformer assembly for
the grill (power supply)
• Convertible regulator set for 4" WCP Natural gas
• Conversion kit for Natural gas
• LP gas fuel tank tray
• 1.5 V "D" size Alkaline batteries
• Vinyl grill cover
Parts Needed - 20 Ib LP gas models
• 20 Ib LP gas fuel tank - approximately 18" (45.7 cm) height
and 12" (30.5 cm) diameter
Parts Supplied
• Convertible regulator set for 4" WCP Natural gas
• 1 single-prong plug/500 mAmp transformer assembly for the
rotisserie motor (on some models)
• 1 single-prong plug/5000 mAmp transformer assembly for
the grill (power supply)
• 1.5-volt "D" size alkaline battery (on some models)
• Rotisserie motor mounting bracket (on some models)
• Rotisserie motor (on some models)
• Rotisserie forks (on some models)
• Rotisserie spit (on some models)
• Smoker box (on some models)
Parts Needed
• Gas line shutoff valve
1/2"male pipe thread nipple for connection to pressure
regulator
LP gas-resistant pipe-joint compound
CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply
line as needed