Dimension Guide

ManualsBrandsKitchenAid ManualsAppliances48 in. W 29.5 cu. ft. Built-In Side by Side Refrigerator in Stainless Steel

PRODUCT MODEL NUMBERS

Side By Side Built-In Refrigerator

KBSD602E KBSD606E KBSD608E

KBSN602E

KBSN608E

Electrical: A 115 volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical supply

is required. It is recommended that a separate circuit serving only your refrigerator

be provided. Use an outlet that cannot be turned off by a switch. Do not use an

extension cord.

Water Pressure: A cold water supply with water pressure between 30 and 120 psi

(207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have

questions about your water pressure, call a licensed, qualiﬁed plumber.

Reverse Osmosis Water Supply:

IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system

gwoing to the water inlet valve of the refrigerator needs to be between 30 and 120 psi

(207 and 827 kPa).

OPENING DIMENSIONS

To avoid tipping during use, the solid sofﬁt must be within 1" (2.5 cm)

maximum above the refrigerator. If the solid sofﬁt is higher than 1"

(2.5 cm) or one is not available, then the refrigerator must be braced.

If the anti-tip boards are needed, they must be attached to the rear wall

studs 80" to 90" (203 cm to 229 cm) above the ﬂoor. See “Install Anti-Tip

Boards” for more information.

NOTE: A clearance of ¹⁄₂" (1.3 cm) above the top grille must

be maintained in order for the top grille to be removed.

IMPORTANT:

It is recommended that you do not install the refrigerator near an oven, radiator, or

other heat source.

Do not install in a location where the temperature will fall below 55°F (13°C).

Floor must support the refrigerator weight, more than 600 lbs (272 kg), door panels

and contents of the refrigerator.

Model Width A (as shown above) Dimension B (as shown above)

35¹⁄₂" to 35³⁄₄"

(90.2 cm to 90.8 cm)

4" (10.2 cm)

41¹⁄₂" to 41³⁄₄"

(105.4 cm to 106.1 cm)

7¹⁄₂" (19.1 cm)

47¹⁄₂" to 47³⁄₄"

(120.7 cm to 121.3 cm)

13¹⁄₂" (34.3 cm)

NOTE: Flooring under refrigerator must be at same level as the room. Face of

cabinetry must be plumb.

PRODUCT DIMENSIONS

The depth from the front of the top grille to the back of the refrigerator cabinet is

5³⁄₈" (64.5 cm).

The power cord is 84" (213 cm) long.

Height dimensions are shown with leveling legs extended ¹⁄₈" (3 mm) below

the rollers.

*When leveling legs are fully extended to 1¹⁄₄" (3.2 cm) below rollers,

add 1¹⁄₈" (2.9 cm) to the height dimensions.

SIDE VIEW

Because Whirlpool Corporation policy includes a continuous commitment to improve

our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation

Instructions packed with product. Specifications subject to change without notice.

Ref. W10763010B

3/16

Page 1 of 2

KBSD612E KBSD618E

Summary of content (2 pages)

PAGE 1
Side By Side Built-In Refrigerator PRODUCT MODEL NUMBERS KBSD602E KBSD612E KBSD606E KBSD618E KBSD608E KBSN602E KBSN608E Electrical: A 115 volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.
PAGE 2
TOP VIEW DOOR SWING DIMENSIONS The location must permit both doors to open to a minimum of 90°. Allow 5" (12.7 cm) minimum space between the side of the refrigerator and a corner wall. NOTE: More clearance may be required if you are using overlay panels, custom handles, or extended handles on a Classic model. To adjust the door swings, see “Adjust Doors.” 36" (91.4 cm) Models Model Width A 36 35" (88.9 cm) 42 41" (104.1 cm) 48 47" (119.