Manual

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
20 Ib LP Gas Models Natural Gas Models
Tools Needed
• Tape measure • Wrench or pliers
• Small, flat-blade screwdriver • Pipe wrench
• Flat-blade screwdriver • Scissors or cutting pliers
• #2 and #3 Phillips screwdriver (to remove tiedowns)
• Level • Noncorrosive leak-
detection solution
Tools Needed
• Tape measure • Wrench or pliers
• Small, flat-blade screwdriver • Pipe wrench
• Flat-blade screwdriver • Scissors or cutting pliers
• #2 and #3 Phillips screwdriver (to remove tiedowns)
• Level • Noncorrosive leak-
detection solution
Parts Supplied
• Gas pressure regulator/hose assembly set for 11" WCP LP
gas (attached to manifold)
• 1 single-prong plug/5,000 mAmp transformer assembly
• Convertible regulator set for 4" WCP Natural gas
• Orifices for Natural gas conversion
• LP gas fuel tank tray
Parts Needed
• 20 Ib LP gas fuel tank - approximately 18" (45.7 cm) height
and 12" (30.5 cm) diameter
Parts Needed
• Gas line shutoff valve
• 1/2"male pipe thread nipple for connection to pressure
regulator
• LP gas-resistant pipe-joint compound
• CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply
line as needed.
Parts Supplied
• Convertible regulator set for 4" WCP Natural gas.
• Single-prong plug/5,000 mAmp transformer assembly