Manual
I _%(*a_HH__?_:__H_"__'__!C
Selectalocationthatprovidesminimumexposuretowindand
trafficpaths.Thelocationshouldbeawayfromstrongdraft
areas.
Donotobstructflowofcombustionandventilationair.
Clearancetocombustibleconstructionforbuilt-inoutdoorside
burners:
• Aminimumof24"(58cm)mustbemaintainedbetweenthe
sidesandbackandanycombustibleconstruction.
• Azeroclearancemaybemaintainedbelowthecooking
surfaceandanycombustibleconstruction.
Ignition
A grounded, 3-prong outdoor GFI outlet is to be located inside
the island cabinet and to the left of the side burner. See
"Electrical Requirements" section.
Style 1 - Front to Back Built-In Dual Side Burners
7-
B
i
A
© ©
E
F
G
A. 13" (33 cm)
B. 10%" (27 cm)
C. 17" (43.2 cm)
D. 26%" (67 cm)
E. 253/8" (64.5 cm)
F. Manifold pipe
G. 4%" (11.1 cm)
H. 223/4'' (57.8 cm)
Style 2 - Side by Side Built-In Dual Side Burners
T
B
i
L
© ©
< C
E_
r"
F
f
A. 24" (61 cm)
B. 10%" (27 em)
C.28" (71.1em)
D.201/_"(52.1 em)
E. 191/_"(49.5 em)
F. Manifold pipe
G. 43/8"(11.1 cm)
H. 17" (43.2 cm)
Built-In Outdoor Side Burner Enclosure
This built-in outdoor side burner is for installation in a built-in
enclosure constructed of combustible and non-combustible
materials. Some types of non-combustible materials could be
brick, firewall or steel. Some types of combustible materials
could be wood or laminate.
The enclosure for the built-in outdoor side burner is to be a
minimum of 11" (28.0 cm) high x 23" (58.4 cm) deep x
14" (35.6 cm) wide for front to back model and 11" (28.0 cm)
high x 17" (43.2 cm) deep x 25" (63.5 cm) wide for side by side
model.
Counter or support surfaces must be level.
The installation of this side burner must conform with local codes
or, in the absence of local codes, with either the National Fuel
Gas Code, ANSI Z223.1/NPFA 54, Natural Gas and Propane
Installation Code, CSA B149.1, or Propane Storage and Handling
Code, B149.2.
Copies of the standards listed may be obtained from:
CSA International
8501 East Pleasant Valley Rd.
Cleveland, Ohio 44131-5575
NOTE: The outdoor side burner drops into the enclosure opening
and is supported by its side flanges. No bottom support is
needed.
6