Instruction for Use

16
Startup
The appliance is configured at the factory with preset values.
Warning: in case of power cut setting parameters are conserved. Only hour and timer programmer are
lost because pcb board has no battery
Before switching the appliance off, a thorough cleaning is necessary, following the instructions of the
“Maintenance and cleaning” section.
- Insert the plug in the electric socket.
- Press the ON key for a few seconds.
- Two minutes after switching the appliance on, the water circulation pump and the cooling system will be
activated.
Maintenance and Cleaning
• Always disconnect the appliance from the electric power supply before performing any maintenance or
cleaning operations.
• Clean the inside of the appliance regularly, using a cloth dampened with a solution of lukewarm water and
neutral detergent. (Cleaning should take place at least once every six months)
• Never use abrasive detergents.
• Do not use steam cleaners.
• The panel keys and display must not be cleaned using alcohol based substances or similar. Only use a dry
cloth.
•
Cleaning the internal tank
• Disconnect the appliance from the electric power supply and remove any left over ice cubes from the
tank.
• Clean using a cloth dampened with a solution of lukewarm water and neutral detergent.
• Remove all limescale traces applying a specific limescale product. Give the product time to act and then
remove with a dry cloth.
Sanitization
Sanitization must be performed by qualified technical service every six months.