Instruction for Use

9
Technical specifications
- Sizes External: 596x455x538
Cabinet hole size: 560x440x560
- Mounting on sliding rails.
- Production:
Rated production: 10 Kg/24h (Ambient temperature 20°C / Water temperature 15°C).
- 12 cubes/cycle
- ice cube weight 22 g
- Ice tank: 8 Kg
- Power supply connection: - Power supply: 220 V / 50 Hz.
- Power: 250 W
- Intensity: 1.8 A
- Water connection - Male thread tap socket ¾” BSP
- Consumption: 2.4 l/h
- Maximum instantaneous capacity: 1 l/min
- Pressure: 1-5 bar
- Cooling - Refrigerant: R134A
- Air condensation. Front input. Back output
Installation
Anchoring of the machine
Extract the water discharge pipes and the power supply cable on the rear of the appliance, by removing the
rear grille. Make sure that the two discharge pipes are installed as shown in the picture and that they are
not bent nor squashed, as this may cause the appliance to malfunction.
Follow the following steps:
1. Screw the guides in the hole of the piece of furniture to have them horizontally and set back 5 mm as it
is indicated on the figure.
2. Screw the fastening bridge of the machine in the position of the drawing.
3. Screw the fastening flanges of the drainage hoses.
4. Place the machine on the support angles of the guides. Adjust the width before fastening the screws
checking that it slides softly along the path.