Troubleshooting guide

5
correctly installed - risk of electric shock.
• Wear work gloves for all installation and
maintenance operations.
• The product is not suitable for outdoor use.
• When the hob is in use, the accessible parts of
the hood can become hot.
Disposal of electrical appliances
• This appliance is manufactured with recyclable
or reusable materials. Scrap it in accordance
with the local waste disposal regulations. Before
scrapping, make it unusable by cutting off the
power cable.
• For further information on the treatment,
recovery and recycling of this appliance, contact
the competent local authority, the household
waste collection service or the shop where you
purchased the appliance.
KEEP THESE INSTRUCTIONS
Installation
After unpacking the appliance, check for any
damage caused during transport. In case of
problems, contact the dealer or the After-Sales
Service. To avoid possible damage, it is advisable to
remove the appliance from the polystyrene base
only before installation.
PREPARATION FOR INSTALLATION
Very heavy product; hood handling and
installation must be carried out by at least
three people.
The distance between the support surface of the
cooking device and the lowest part of the hood
must not be less than 100 cm, irrespective of the
type of hob (electric, vitroceramic, induction or
gas).
The following nominal power stresses (kW) must
not be exceeded above the gas cooking points:
Max. power of a single cooking point: 4.2 kW.
Max. power of hob: 16.2 kW.
Before installation, also check the distances
specified in the hob manual.
If the cooking device installation instructions specify
a greater distance, this distance must be taken into
account.
CONNECTION TO THE POWER SUPPLY
Make sure the voltage specified on the product's
dataplate is the same as the mains voltage. The
dataplate is located inside the hood, and can be
seen on removing the grease filter.
The power cable ((H05 VV-F type) must only be
replaced by qualified personnel. Contact an
authorised Service Centre.
If provided with a plug, connect the appliance to a
socket complying with the current regulations and
located in an accessible area. If it does not have a
plug (direct connection to the power supply) or if
the socket is not in an accessible place, fit an
approved double-pole switch that ensures
complete disconnection from the power supply in
category III overvoltage conditions, complying with
the installation rules.
GENERAL RECOMMENDATIONS
Before use
Remove cardboard protection pieces, protective
film and stickers from accessories.
Make sure the hood has not been damaged during
transport.
During use
Do not expose the appliance to atmospheric
agents.
WARNING