Operation Manual

support

bracket

mounting height reference

centre line

support

bracket

hooks

bottom fastener

locations Ø 8 mm

hooks

REAR VIEW

bottom screw hole

(inside the canopy)

FRONT VIEW

Fig. 4

• Using a pencil, draw a line on the wall up to the

ceiling that corresponds with the centre line;

this will make installation easier.

• Establish the most suitable distance from the

work surfaces according to your needs

(Important! Respect the minimum distances

indicated on p6 of this instruction booklet),

draw a horizontal line on the wall corresponding

to this distance and apply the perforation layout:

the vertical centre line printed on the

perforation layout should correspond with the

centre line drawn on the wall; furthermore the

lower edge of the perforation layout should

correspond with the horizontal line drawn.

• Place the lower support bracket on the

perforation layout making it coincide with the

sketched rectangle. Mark the two external holes

then drill the holes. Remove the perforation

layout and insert 2 wall plugs and fix the hood

support bracket with 2 x45mm screws.

Fig. 5

• Hang the hood on the lower bracket.

• Adjust the distance of the hood from the wall.

• Adjust the horizontal position of the hood.

• From the inside of the hood, make 2 pencil

marks for the holes ready for the final fitting of

the hood.

• Remove the hood from the lower bracket.

• Drill in the points indicated.

• Insert 2 wall plugs.

Installation