Installation Instructions

2
COOKTOP SAFETY
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed
n Tape measure
n Flat-blade screwdriver
n Phillips head screwdriver
n Drill
n Level
n 6" (15.2 cm) socket
extension
n Marker or pencil
n Pliers
n 1/4" (6.4 mm) drill bit
n Jigsaw
n Ratchet with 3/8"
(9.5mm) socket
n 1/4" (6.4 mm) nut driver
Parts supplied
n Vent grille
n Pre-lter
n Plenum
n Plenum screw pack
n Downdraft motor
assembly
Parts needed
n A UL Listed or CSA Approved strain relief for 7/8" (2.2 cm)
knockout.
n A UL Listed or CSA Approved conduit connector for 1/2"
(1.3 cm) trade-size metal-clad conduit
n UL Listed wire connectors
n Metal ducting
n Wall cap
6" (15.2 cm) Round Surface Wall Cap Damper Order Part
Number A406
3
1
/
4
" x 10" (8.3 cm x 25.4 cm) Surface Wall Cap Damper
Order Part Number A403
To order, see the “Assistance or Service” section of the Use
and Care Guide.
n Vent clamps
Check local codes. Check existing electrical supply.
See the “Electrical Requirements” section.
It is recommended that all electrical connections be made
by a licensed, qualied electrical installer.
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't
follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING