User Manual

6
Functions
EXTENDIBLE ZONE (DOUBLE ZONE)
Depending on the diameter of the container, the zone adapts itself
automatically, turning on partially (inner zone) or completely (outer
zone). For more information, refer to the minimum diameter table.
IMPORTANT: Place the pot making sure that its center
corresponds to the center of the cooking zone in use.
ASSISTED SENSOR COOKING
The “Asst” button activates the special sensor cooking functions.
Place the pot in position and turn on the cooking zone. Then press
the “Asst” button. “A” will appear on the display. The indicator for
the rst special feature available for the cooking zone will light up.
In order to skip to the next one press the “Asst” button again. If
no button is pressed the function is activated automatically after
3seconds.
Conrm the selection by pressing the “Asst” button when the
cooktop sounds.
The power level is not editable. The cooktop sets a default power
level. To deactivate the special functions, press “ON/OFF” button
or press “Asst” button until a dash “-” is visible on the display.
ASSISTED FRY
The ideal function for preheating an empty pan or a pan with oil
up to a maximum height of 3/8" (1 cm) to the best temperature
for frying. At the end of the heating stage, the cooktop will make
a sound to alert you that it is time to move to the next cooking
stage. The cooktop will stabilize the temperature and, if necessary,
adjust to keep consistent. Press the “Asst” button to conrm that
the food is going to be placed in the pan then the cooktop will
move to the next stage. It is best to use this function when both
the pan and oil are at room temperature. For best results, it is
recommended to use this function with the suggested accessory
(See Assistance or Service section to Order Accessories).
Asst
Asst
Daily Use
POSITIONING
Do not cover the control panel symbols with the cooking pot.
NOTE: In the cooking zones close to the control panel, it is
advisable to keep pots and pans inside the markings (taking both
the bottom of the pan and the upper edge into consideration, as
this tends to be larger).
This prevents excessive overheating of the keypad. When grilling
or frying, use the rear cooking zones.
NOTE: Do not set any items on the control panel at any time.
To Use:
Press “ON/OFF” for at least one second to turn on the desired
cooking zone. A dash (“-”) will be shown on display. Press the “+”
or “−” button of the required cooking zone to adjust the power. At
rst the level “5” will be shown in line with the area.
The Boost function is reached by pressing the power level button
until the letter “P” is shown in the digit display. The boost can be
activated on all zones.
To deactivate the cooking zones:
Select the “ON/OFF” button of the cooking zone desired.
CONTROL PANEL LOCK
To lock the settings and prevent it from being switched on
unintentionally, press and hold the “Key Lock” button for
3seconds. A beep and an indicator light above the symbol
indicates that this function has been activated. The control panel is
locked except “ON/OFF” of each cooking zone.
To unlock the controls, repeat the activation procedure.
TIMER
The cooktop has a Timer. The Timer can be set in minutes up to
99 minutes.
To Use Timer:
1. Press “+” button to select the desired time.
NOTE: Press and hold the “+” or “-” buttons for a few seconds
to quickly scroll through the time.
2. After releasing the button, the timer countdown will start in
3 seconds.
3. If needed to adjust the time, press “+” button to increase the
time or “-” button to decrease the time.
4. When countdown is over, timer tone will sound. The display
will indicate “00” and chime will play some times.
Then the display will turn off.
To Cancel:
Press “-” button until display shows “00” or press simultaneously
“-” and “+”.
WARNING
Fire Hazard
Turn off all controls when done cooking.
Failure to do so can result in death or fire.
A. Single size
B. Dual size