Manualshelf

Owner's Manual

ManualsBrandsKitchenAid ManualsCoffee Collection12 Cup Drip Coffee Maker with Spiral Showerhead and Programmable Warming Plate
12345678910
8
PRODUCT USAGE
PROGRAMMING THE AUTO SET FEATURE
NOTE: Default standard brewing cycle time for a full Carafe (12 cups) is approximately
10-minutes.
IMPORTANT: Set the correct time as per the instructions in “Setting the clock” before
using the Auto Set feature.
Auto 12 12
AM
PM
x
Auto Set 2Auto Set 1
Brew/Cancel
Hour Minute
Plate Temp Plate Timer
CleanBold
Auto 12 12
AM
PM
x
Auto Set 2Auto Set 1
Brew/Cancel
Hour Minute
Plate Temp Plate Timer
CleanBold
Press the Auto Set 1 or Auto Set 2 button
one time.
The Auto 1 or 2 indicator light will flash
and the time display will change to the
currently set Auto Set time
(12:00 A.M is the default time).
To set the time the Coffee Maker should
begin brewing: Press the Hour button to
set hour. The hour digits will change with
each press; or press and hold to scroll
rapidly.
Auto 12 12
AM
PM
x
Auto Set 2Auto Set 1
Brew/Cancel
Hour Minute
Plate Temp Plate Timer
CleanBold
Auto 12 12
AM
PM
x
Auto Set 2Auto Set 1
Brew/Cancel
Hour Minute
Plate Temp Plate Timer
CleanBold
Next, press the Minute button to set
minute. The hour setting will stay solid and
the minute setting will begin to blink.
To save the Auto set time and exit set-up:
Press any other button or do not press
any button for 10 seconds. The Auto 1
or 2 indicator will remain lit and the time
display will go back to the current time.
TIP: To cancel the Auto Set 1 or 2 time after programming is complete: Press Auto Set 1
or Auto Set 2 button again; or press the Brew/Cancel button.
1 2
USING THE PREVIOUSLY PROGRAMMED AUTO SET TIME
These steps can be followed to save the Auto Set time after following the steps in the
“Programming the Auto Set feature” section.
Auto 12 12
AM
PM
x
Auto Set 2Auto Set 1
Brew/Cancel
Hour Minute
Plate Temp Plate Timer
CleanBold
Auto 12 12
AM
PM
x
Auto Set 2Auto Set 1
Brew/Cancel
Hour Minute
Plate Temp Plate Timer
CleanBold
Press the Auto Set 1 or Auto Set 2
button.
The Auto indicator will flash and the time
display will show the previously set Auto
time.
To save the current displayed time and exit
Auto Set: Wait for 10 seconds, or press
any button (Clean, Bold or Brew). The
Auto indicator will remain lit and the time
display will go back to the current time.
1 2
W11418578A.indb 8W11418578A.indb 8 2/19/2020 2:21:16 PM2/19/2020 2:21:16 PM