Operation Manual

Fig. 1
• Pull the handle F and remove the grease filters
(1).
Note: the number of grease filters can vary
depending on the size of the hood.
• Remove the screws that hold on the upper lids
(the 900mm width model has 1 lid, models with a
larger width come with 2 lids, right and left) (2).
Note: the screws to be removed can be found
in the positions indicated by the arrows in fig.
1.1 and 1.2 (only the 900mm width model).
• Remove the cladding (3).
• Attach the connection ring B with 4 screws (4).
Note: If necessary and/or foreseen for your
installation, attach the reducer to the
connection ring B. Without the reducer, pipes
with a diameter of 200mm should be used; with
the reducer you can use a venting pipe with a
diameter of 150mm.
Installation
7