Use and Care Guide

10
CONTROLS AND CYCLE STATUS
Control Purpose Comments
Start
RESUME
To start or resume
a wash cycle.
If the door is opened during a cycle or the power is interrupted, the
Start/RESUME indicator ashes.
Cancel
Drain
To cancel a wash
cycle after it has
been started
Close the door rmly. Touch and hold Cancel/DRAIN for 3 seconds. The
dishwasher starts a 2-minute drain (if needed). Let dishwasher drain
completely.
Hi-Temp
Wash
Sound on/Off
Hold 3 Sec
To turn the audible
tones on or off.
Touch and hold Hi-Temp Wash for 3 seconds to turn the audible tones on or
off. Only audible tones for conrming keypad touches can be turned
on/off. Important audible tones, such as indicating a cycle has been
interrupted, cannot be deactivated.
To indicate the
status of the cycle.
The display will indicate cycle progress such as Washing, Drying, Clean, and
Sanitized. The cycle has completed when the Clean light is lit. If you select the
Sani Rinse option, when the cycle is nished, the Sanitized indicator glows. If
the dishwasher did not properly sanitize your dishes, the Sanitized indicator
ashes at the end of the cycle. This can happen if the cycle is interrupted or
if water could not be heated to required temperature. The light goes off when
you open and close door or touch Cancel.
Canceling a Cycle
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop before completely opening the door.
2. Press and hold Cancel/DRAIN once. The Cancel/DRAIN light
will light up.
3. Close the door and the dishwasher starts a drain cycle (if
water remains in bottom of dishwasher). Let the dishwasher
drain completely. The Cancel/DRAIN light turns off after2
minutes.
Changing a Cycle After Dishwasher Is Started
You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure:
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover
is open, you will need to rell the detergent dispenser before
restarting your new cycle.
3. Press Cancel/DRAIN and wait approximately 2 minutes until
the machine drains and the Cancel/DRAIN light turns off.
4. Select new cycles and options.
5. Press Start/RESUME.
Adding a Dish After Dishwasher Is Started
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop and then completely open the door.
2. If the detergent dispenser door is closed you may add a dish.
If the detergent dispenser door is already opened an added
dish might not be cleaned.
3. Press Start/RESUME and close the door. If the door is not
closed within 4 seconds, you will hear a series of beeps and
the dishwasher will not start.