Use and Care Guide

11
Dishwasher Features
Silverware Basket
Silverware basket lids:
Use silverware basket lids to provide optimal spacing and best
cleaning performance.
NOTE: If your silverware does not t into the designated slots,
push tabs inward on either end and lift lid off of the silverware
baskets. Mix silverware types to keep them separated. Load
knives down, forks up, and alternate spoons for best cleaning
results.
Cup Shelves
Fold down the extra shelf on the right-hand side of the top rack
to hold additional cups, stemware, or long items such as utensils
and spatulas. For best results on cups, stagger the spacing so
that the cups on the shelf are not directly above the cups below.
Premium Adjustable 2-Position Top Rack
You can raise or lower the top rack to t tall items in either the
top or bottom rack. Adjusters are located on each side of the top
rack.
To raise the rack:
Press both rack adjuster
thumb levers and lift the rack
until it is in the up position
and level.
To lower the rack:
Press both rack adjuster
thumb levers and slide the
rack to its down position
and level.
NOTE: The top rack must be level.
Removable Top Rack
The removable top rack
allows you to wash
larger items such as
pots, roasters, and
cookie sheets in the
bottom rack.
IMPORTANT: Remove dishes
prior to removing the top rack
from the dishwasher.
To remove the rack:
To gain access to the
removable tabs on the
tracks/rails, pull the upper
rack forward about
halfway out of the tub.
On one side, press the tab on the track in and pull up the front
end of the rack, out of the track. Then repeat this step on the
other side to completely remove the front end of the rack.
Then remove the rack by pulling the back end out using a
forward and upward motion.
To replace the rack:
Pull the tracks forward about halfway out of the tub.
Along the sides of the racks are round attachment tabs. Align
the rack’s back end attachment tabs with the cutout in the track.
Push down into place.
Pull the tracks completely out, and align the rack’s front end
attachment tabs with the cutout in the track. Push down into
place. You will hear a snap when the front end of the rack is
secured into place on each side.