Operation Manual

15
Rinse aid
Pour in rinse aid
Rinse aid, helps quicken the drying process.
Machines with indicator on the panel
When the rinse aid has run out and more is
needed, the rinse aid symbol on the panel lights
up*.
To fill with rinse aid:
1. Turn and lift up the cover of the rinse aid
compartment to the right of the dispenser. This
is where you top up and set the amount of rinse
aid to be dispensed in each wash.
2. Carefully pour in rinse aid up to the knob for
dosage setting.
Alter dosage if required. Do not forget to close the
cover.
*NB!
After filling there may be a short delay before the
signal light goes out.
Machines with refill indicator
There is a refill indicator in the middle of the
dispenser (see picture). If the refill indicator is
totally black, there is sufficient rinse aid. However,
if the indicator has a more transparent appearance,
you need to top up with rinse aid (see above).
Select dosage
The dispenser is usually set at 1= soft water.
However, depending on the water hardness, it may
be necessary to change the dosage.
Open the rinse aid cover . Here you will find the
dispenser's adjustment dial. Settings 1-6: the harder
the water, the higher the dosage.
When the water hardness exceeds 10-12 odH you
should use rinse aid with citric acid (acid rinse aid)
if the machine does not have a water softening
filter. If the machine has a water softening filter,
dispense as for soft water.
Too much rinse aid can lead to the build-up of
foam. If your water is particularly soft, you can
dilute the rinse aid (1 part rinse aid, 1 part water).
Too much rinse aid can cause streaks on the dishes,
while too little can result in water stains.
Refill indicator
Open
Closed
Cover for rinse aid
Open by turning and lifting the cover!