Operation Manual

17
Settings
Reprogramming
Some of the machine's functions can be
reprogrammed. You get into the machine's change
program using the machine's ordinary buttons as
per the instructions below. The selection will be
retained until the next time you reset this function.
Even if the machine is turned off at the main switch
or loses power for any other reason,
all selections registered before the interruption of
power will be retained.
Child-safe button lock
You can prevent a child starting the machine by
accident or changing the settings by programming
the machine with a button lock, which requires the
Temperature and Drying buttons to be pressed
simultaneously to start up the machine. The button
lock will automatically be reactivated after three
minutes.
1. Switch off the dishwasher with the main switch.
+
2. Hold in the Temperature and Drying buttons
while pressing the main switch. The
Temperature, Drying and start symbols will
flash. Release the Temperature and Drying
buttons.
3. Press the Program button - when the AUTO
wash symbol is lit, the button lock has been
activated.
4. Then press the Start/Stop button to confirm the
setting.
or Reset:
1. Switch off the dishwasher with the main switch.
+
2. Hold in the Temperature and Drying buttons at
the same time as pressing the main switch.
3. Press the Program button - when the AUTO
wash symbol goes out the button lock has been
deactivated.
4. Then press the Start/Stop button to store the
setting.
Setting water hardness
If you have a dishwasher with a water softener, you
may need to change the setting, depending on the
degree of hardness of the water. Phone your local
Water Board to check the water hardness in your
area. The dishwasher is set for low water hardness
on delivery.
1. Switch off the dishwasher with the main switch.
2. Press the main switch while holding in the
Start/Stop switch. Release the Start/Stop button.
3. Press the Program button from one to six times
depending on the hardness of the water.
Program symbols will light up as you press. See
illustration.
* All program indicators extinguished: Machines
without water softeners and machines with water
softeners and low water hardness.
4. Press the Start/Stop button and the setting will
be stored until next time you want to make a
change.
Setting water hardness °dH °fH
* * * * * * 0-5 0-9
6-8 9-14
9-14 15-25
15-19 26-34
20-29 35-52
30-44 53-79
45+ 80+