Operation Manual

18
Setting a signal
If you want the machine to signal when the wash is
complete, you can program it to do this. The
machine is set without a signal by default.
1. Switch off the dishwasher at the main switch.
2. Hold in the Delayed start button at the same
time as you press the main switch. The button
flashes. Release the button.
3. Press the Program button - when the Auto
wash symbol lights, the signal is activated.
4. Press the Start/Stop button and the setting will
be stored until next time you want to make a
change.
or Reset
1. Switch off the dishwasher with the main switch.
2. Hold in the Delayed start button at the same
time as you press the main switch. The button
flashes. Release the button.
3. Press the Program button - when the Auto
wash symbol goes out, the signal is deactivated.
4. Press the Start/Stop button and the setting will
be stored until next time you want to make a
change.
Fault indications
To remove the fault indications from the display, turn off the main switch and then turn it back on again.
Display Type of fault Action
flashes
Too much water in the
dishwasher
Phone service
flashes
Fault with water inlet tap is
open
Check that the water
flashes Valve leakage
Shut off the water tap and
contact service
flashes Blocked drain
See 'Possible causes' in
chapter Trouble shooting
flashes Clogged filter
Clean the filters, see
chapter Cleaning