Operation Manual

20
Problems Possible causes Action
Rattling sound during dishwashing • The dishes are not properly loaded
or the spray arms are not rotating
• Check that the china is loaded
securely. Spin the spray arms to
make sure that they rotate
The machine will not start • You have forgotten to switch on the
main switch
• Check
• The door is not properly closed • Check
• A fuse has blown • Check
• The plug is not plugged in • Check
• The water tap is off • Check
• Overfilling/leakage
To restart the machine, press
Start/stop for 3 seconds. Now
select a new programme and
press Start/stop.
• A droning sound (drainage pump)
can be heard from the machine,
this does not stop when the power
is switched off using the main
power switch.
1. Close the water tap.
2. Pull out the plug.
3. Call a service engineer
Water remains in the machine • Obstruction in the drain hose • Disconnect the drain hose where it
is connected to the sink's water
trap. Check that no debris has
become stuck. Is the cone-shaped
part of the pipe cut so that the
diameter is at least 16 mm?
• Kinks in the drain hose • Check that the hose is free from
kinks or sharp bends
• The filters are clogged • Clean out the coarse filter, the fine
filter and the filter
• Items in the drain pump • Clean out the drain pump. See
chapter on cleaning
Bad odor in the machine • Dirt along the strips and in corners • Clean with a dish brush and low-
lather detergent
• Low-temperature programs have
been selected for a prolonged
period
• Run a Normal Temperature
program around once a month
• Drying power too low. The
machine is not fully loaded
• Activate the Normal drying option
(not all models). Put a full load in
the machine
The dishes are not sufficiently dry • The rinse aid has run out or the set
dose is too low
• Replenish rinse aid or increase the
dose of rinse aid if required
• Open the door slightly once the
program has finished