Operation Manual

23
Installation and connection information
DISHWASHER CAVITY MEASUREMENTS
DISHWASHER MEASUREMENTS
*With nut and sliding protection mounted
**Recommended measurements
WATER CONNECTION
• The machine can be connected to a cold or hot
water supply (maximum 85°C). However, we
recommend connection to a cold water supply.
• The inlet pipe has a connector with either a 1/2"
internal thread.
ELECTRICAL CONNECTION
• 220-230VAC mains voltage, minimum 13A
DRAINAGE
• The supplied cone-shaped connection pipe fits a
drainage connection with an internal diameter
of 13, 16, 18 and 22 mm.
• Use a hose clamp if connecting to a fixed drain
(sink).
The connector is ready to cut to the desired drain
connection size. Only a clamp is required.
CABLE/HOSE LENGTHS
Drainage hose: 1930 mm
Supply hose: 1670 mm
Power cable: 1770 mm
TOOLS
1) Flathead screwdriver
2) Open-ended spanner 16 mm
3) Tape measure
4) Spirit level
Step 1. Fitting the dishwasher in place
1. Loosen the locking nuts on the dishwasher's
two front steel feet using a 16 mm open-ended
spanner. Screw the locking nuts down as close
to the floor as possible.
2. Adjust the height of the dishwasher by turning
the front steel feet with your hands. Leave
enough space to adjust them later.
Make sure the
edges of the
cable hole are
even so as not
to damage the
drainage and
supply hoses
and the
electric cable.
Cable hole