Operation Manual

24
3. Screw in the back foot completely by turning
the adjustment screw at the front anticlockwise.
Use a flat-bladed screwdriver or an Allen key.
4. Push the plastic feet into place on all three steel
feet (included in document bag).
Note:
Do not attach the plastic feet if the installation
space is of minimum height.
5. Push the dishwasher into the cavity. At the same
time, pull the electric cable and drainage and
supply hoses through the cable hole.
6. Lift the dishwasher a little at the front and turn
the front feet to lower them.
7. Check that there is a space of 3 mm between
the top of the dishwasher door and the
underside of the worktop.
Do not attach the locking nuts. This will be done
later.
8. Adjust the back foot by turning the adjustment
screw at the front clockwise.