Operation Manual

26
2. Loosen the spring from the rear mount by turning it
outwards.
3. Adjust the spring tension using one of the following
methods depending on how much adjustment is
needed.
If you need to adjust the spring a lot, place the rear
mount in another hole. Place the spring further
forward to reduce the tension and further back to
increase the tension.
If you want to make small adjustments to the spring,
hold the back end with one hand and turn the forward
mount clockwise or anticlockwise one or more times.
Turn the mount clockwise to increase spring tension
and anticlockwise to reduce spring tension.
4. Replace the back end of the spring by holding
the spring at a right angle to the side of the
dishwasher and pushing the end of the spring
into the hole, then turning the spring in towards
the dishwasher.
5. Reattach the front end of the spring by pulling it
up and forward to fasten it in the mount.
6.
Open the door and check the spring tension again.
If necessary, make further adjustments as above.
Stronger door springs are available for purchase for
dishwashers fitted with a cover door. Springs are
available for various weights and sizes of door.
Door springs can be purchased from the retailer
who sold you the dishwasher.
Step 4. Connecting electricity, water and drain
1. Connect drain hose
The drain hose runs to an inlet plug on the sink
unit's water trap.
Reduce spring tension
Increase spring tension
Reduce spring tension
Increase spring tension
Connection pipe
Clamp
Water connection
Hose barb
coupling
4
5