Operation Manual

27
Note:
The hose must be fastened on a level with the
underside of the sink unit.
Cut the drain hose adapter to the appropriate size
for connection to the undersink drain or garbage
disposer. The overall length of the drainage hose
must not exceed 4,5 m.
No part of the drainage hose may be more than
950 mm above the bottom of the dishwasher.
The hose must not be run directly to the floor
drain or similar.
The hose must always discharge at least 350 mm
above the bottom of the dishwasher.
2. Connect water supply hose
Connect using the supplied O ring and tighten
the connection by hand plus a quarter turn with
a wrench. Open the shutoff valve and let the
pressure settle for a while. Check the
connections again to make sure they are not
leaking.
3. Connect the electric plug
Ensure that the power socket is within the
range of the power cable. Do not use an
extension cord! The dishwasher must be
connected to a grounded outlet.
Step 5. Checking dishwasher function and fit
Test the dishwasher with the rinse program. Check
that the dishwasher takes in water and drains. Also
check that none of the connections leak.
Also check that adjacent drawers and cupboards
can be opened when the dishwasher door is open.
Step 6. Securing the dishwasher
1. Pull out the upper basket, and the centre basket
if present, and turn the basket stop on the
runner outwards.
2. Remove the upper basket, and the centre
basket if present, by pulling the basket(s) out as
far as possible. This is to make more space
available during installation.
3. Remove the lower basket. Otherwise it easily
rolls out if you need to adjust the dishwasher
during installation.
4. Connec. Screw the dishwasher to the worktop
from the inside or to the cabinets on either
side. If the worktop is a hard material, such as
marble, screw the dishwasher to the side
cabinets. Use the supplied plastic spacers when
screwing the dishwasher into place!
Water connection
Shut off valve
Grounded
outlet
Grounded
outlet
Securing to worktop
Securing to side cabinets