Operation Manual

18
Rinse aid
Adding rinse aid
In some cases, drying can be made more efficient
by using rinse aid.
Machines with indicator on the panel
When the rinse aid has run out and more is
needed, the rinse aid symbol on the panel lights
up*.
To fill with rinse aid:
1. Turn and lift up the cover of the rinse aid
compartment to the right of the dispenser. This
is where you top up and set the amount of rinse
aid to be dispensed in each wash.
2. Carefully pour in rinse aid up to the dosage
setting knob.
Alter dosage if required. Do not forget to close the
cover.
*Note!
After filling there may be a short delay before the
signal light goes out.
Machines with refill indicator in detergent
dispenser
There is a refill indicator in the middle of the
dispenser (see illustration). If the refill indicator is
totally black, there is sufficient rinse aid. However,
if the indicator has a more transparent appearance,
you need to top up with rinse aid (see above).
Select dosage
The dispenser is usually set at 1= soft water.
However, depending on the water hardness, you
may need to change the dosage.
Open the rinse aid cover. Here you will find the
dispenser's adjustment dial. Settings 1-6: the harder
the water, the higher the dosage.
When the water hardness exceeds 3 grains, you
should use rinse aid with citric acid (acid rinse aid).
Too much rinse aid can lead to the build-up of
foam. If your water is particularly soft, you can
dilute the rinse aid (1 part rinse aid, 1 part water).
Too much rinse aid can cause streaks on the dishes,
while too little can result in water stains.
Refill indicator
Open
Closed
Cover for rinse aid
Open by turning and lifting the cover!