Operation Manual

19
Salt
Add salt
Before using a dishwasher with a water softening
filter, you must fill the salt compartment with salt.
Use coarse salt or special salt for dishwashers.
It is best to fill with salt when you are about to do
a wash, as the dishwasher needs to be rinsed out
immediately after filling.
Proceed as follows the first time:
1. First unscrew the cover as illustrated.
2. Place the funnel, which is supplied with the
dishwasher, into the compartment's filler hole.
3. First pour in approximately 1 litre of water.
Then fill the compartment with max 1.5 kg of
salt.
4. Wipe away excess salt so that the cover can be
properly screwed into place.
5. Run a Normal wash program so that any salt in
the machine is rinsed away.
When the salt runs out, the salt symbol on the
display* lights up. Unscrew the cover and fill the
compartment with salt. Water is only needed on
the first occasion! Wipe clean and screw back in
place. Run a Normal wash program so that any salt
is rinsed away.
Occasionally check to see if more salt is needed.
A green indicator can be seen in the cover of the
salt compartment.
The indicator is not working
If the indicator is not working, this may be because
the float, which is positioned under the cover, has
become stuck in salt residue. The float can be
reached through the green arm located under the
cover of the salt compartment.
1. Move the float arm up and down to loosen it.
2. Once the float has been loosened, press it
down again.
Models without a salt symbol in the display show
green in the salt compartment cover when there is
sufficient salt.
*NB!
After filling, there may be a short delay before the
signal light goes out.
CAUTION!
Never pour dishwasher detergent into the salt
compartment. It will destroy the water softener!
Cover for the salt compartment