Operation Manual
20
Fault indications
To remove the fault indications from the display, turn off the main switch and then turn it back on again.
Display Type of fault Action
Overfilling Too much water in the machine Phone for service
Water inlet fault Fault in the water inlet Check that the tap is open
Inlet valve Inlet valve leakage
Shut off the tap and phone for leakage
service
Drainage fault Blocked drain
See 'Possible causes' in chapter
Troubleshooting
Blocked filter Clogged filter Clean filters, see chapter Cleaning
Troubleshooting
Problems Possible causes Action
The dishes are not clean
• The spray arms are not rotating • Lift off the arms and clean
• Old dishwasher detergent.
Note! Detergent is perishable
• Avoid large packs
• Incorrect dosage of detergent
• Dispense according to the level of
water hardness
• Wrong wash program selected
• Heavier programs are longer, and
use higher temperatures for dirtier
loads. Use a heavier program
better suited for the load
• Incorrect loading of the dishwasher
• Do not cover china with large
bowls or the like
• Try not to place too much tall
glassware in the corners of the
baskets
• Glasses and cups have tipped over
during the wash
• Load the china securely
• Filter not correctly positioned • Screw the filter into place
Stains or a film on the china
• Dishwasher fitted with water
softener is leaking salt
• Check that the cover of the salt
compartment is properly screwed
on. Otherwise phone for Service
• The salt compartment is empty • Top up with salt
• Incorrectly set rinse aid dispenser • See the chapter on rinse aid
• Phosphate-free detergent in
combination with hard water
• Change detergent
• Too high a temperature and/or too
much detergent can cause etching
on(crystal) glass. Unfortunately this
cannot be remedied, only
prevented!
• Wash (crystal) glass at a low
temperature and use dishwasher
detergent sparingly.
Contact the dishwasher detergent
manufacturer
The china has a whitish-blue sticky
film
• Too high dosage of rinse aid
• Reduce dosage. See the chapter on
rinse aid. If the water is very soft,
you could try diluting the rinse aid
with water (1 part rinse aid, 1 part
water)