Operation Manual

21
Problems Possible causes Action
Stains on stainless steel or silver
• Certain food remnants such as
mustard, mayonnaise, lemon,
vinegar, salt, and dressings can
cause stains on stainless steel if
allowed to remain for any length of
time. All stainless steel can mark
silver if allowed to come into
contact during the dishwashing
process. Aluminum can also cause
stains on dishes
• Rinse off food residue of this type if
you do not intend to start the
dishwasher immediately
• Seperate your cutlery into various
compartments in the basket. Make
sure silver and stainless steel are
not together
Stains which remain after
dishwashing
• Lipstick and tea can be difficult to
remove
• Heavier programs are longer, and
use higher temperatures for dirtier
loads. Use a heavier program
better suited for the load
Rattling sound during dishwashing
• The dishes are not properly loaded
or the spray arms are not rotating
• Check that the china is loaded
securely. Spin the spray arms to
make sure they rotate
The machine will not start
• You have forgotten to switch on the
main switch
• Check
• The door is not closed properly • Check
• The home's circuit breaker has
tripped
• Check
• The plug is not plugged in • Check
• The water tap is off • Check
• Overfilling/leakage
• Contact our Customer Care
Center
• A whirring sound (the drain pump)
is heard from the machine, which
ceases when the power is turned
off at the main power switch
1. Shut off the water tap
2. Unplug the electrical plug from the
outlet
3. Contact our Customer Care
Center at the number at the
bottom of the page
Water remains in the machine
• Obstruction in the drain hose
• Disconnect the drain hose where it
is connected to the sink's water
trap. Check that no debris has
become stuck. Is the cone-shaped
part of the pipe cut so that the
diameter is at least 16 mm?
• Kinks in the drain hose
• Check that the hose is free from
kinks or sharp bends
• The filters are clogged
• Clean out the coarse filter, the fine
filter and the filter
• Objects in the drain pump
• Clean out the drain pump. See the
chapter on cleaning
• Dirt around edges and corners
• Clean with a dishwashing brush and
low-foaming detergent
Bad odor in the machine • Dirt along the strips and in corners
• Clean with a dish brush and low-
lather detergent
Dishes do not get sufficiently dry
• The Economy dry option has been
selected
• Activate the Normal drying option
• The machine is not fully loaded • Load the machine full
• Rinse aid is out or set for too small
a dosage
• Fill or increase the amount of rinse
aid
• Open the door slightly once the
program has finished