Installation Guide

20
DIRECT WIRE CONNECTION
Use a
1
/
4
" nut driver or
1
/
4
" hex head socket wrench to remove
the screw that holds the terminal box to the cross brace. Then,
tilt the terminal box, free the tab, and lift the terminal box away
from the crossbar.
Remove the cover by sliding it up and lifting its hooks out of
the slots. Retain cover for later use.
There should be adequate length in the wires to pull the
terminal box out from under the dishwasher. Lift the wires
off of the nearby clips or components to extend the length
of wire harness for easier access.
51. Remove terminal box
52. Remove cover
53. Unclip green, white, and black wires
IMPORTANT: Check that top of door does not contact screws,
brackets, or countertop. If it does, adjust leveling legs or use
the side attachment option.
Open door and check that space between dishwasher cabinet
opening and tub is equal on both sides. If spacing is not equal,
loosen bracket screws and shift tub. Tighten bracket screws.
If side attachment method was used, reinstall the gray plastic
buttons removed in Step 39 to hide the screw holes.
48. Check door clearance
49. Check inner spacing
50. Reinstall plastic buttons
Plastic button