Use and Care Manual

5
OPTIONS CAN BE
SELECTED
WITH
WHAT IT DOES ADDED TIME
TO CYCLE
(HR:MIN)
ADDED
WATER
GALLONS
(LITERS)
Dries dishes with heat and a fan. This option, with
the use of rinse aid, will provide the best drying
performance. Plastic items are less likely to deform
when loaded in the top rack. Turn the ProDry™
option off for an air dry.
Available
with any
cycle except
Rinse Only
Uses the heating
element, vents, and
a fan to speed drying
times. ProDry™ option
defaults to On when
any cycle is selected,
except for Express
Wash and Rinse Only.
ProDry™:
0:40 to 0:50
Extended
ProDry™
(includes
ProDry™ time):
1:10 to 1:20
0
Lower jets clean pans, casseroles, etc., with tough
food soil to eliminate the need for soaking and
scrubbing of dirty, baked-on dishes. The upper
rack has two spray zones in the front corners to
reach into deeper or oddly shaped items.
ProWash™
Tough
Normal
Activates the
ProScrub
®
spray jets
to provide intensified
cleaning power to
specific wash areas.
0:05 to 2:00 0 to 3.0
(0 to 11.2)
Raises the main wash temperature to improve
cleaning for loads containing tough, baked-on food.
ProWash™
Tough
Normal
Raises the main wash
temperate from 105°F
(41°C) to either 130°F
(55°C) or 140°F (60°C).
0:00 to 0:30 0 to 3.0
(0 to 11.2)
Sanitizes dishes and glassware in accordance
with NSF International NSF/ANSI Standard 184
for Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food
establishments. Only sanitizing cycles have been
designed to meet the requirements of the NSF/
ANSI 184 performance standard for soil removal
and for sanitization efficacy. There is no intention,
either directly or indirectly, that all cycles on a
NSF/ANSI 184 certified dishwasher meet the NSF/
ANSI 184 performance standard for soil removal
and for sanitization efficacy.
The Sani Rinse indicator glows at the end of the
cycle if the Sani Rinse option was successfully
completed. If the indicator does not activate, it is
probably due to the cycle being interrupted.
ProWash™
Tough
Normal
Increases the main
wash temperature from
105°F (41°C) to 140°F
(60°C) and the final
rinse from 140°F (60°C)
to 155°F (68°C).
0:10 to 2:00 0 to 3.0
(0 to 11.2)
Runs the dishwasher at a later time or during
off-peak electrical hours. Select a wash cycle and
options. Touch the Delay keypad. Touch START/
RESUME. Close the door firmly.
NOTE: Anytime the door is opened (such as, to
add a dish), the Start/Resume keypad must be
touched again to resume the delay countdown.
Available
with any
cycle
Delays the start
of a cycle to the
specified time.
0
Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, touch and hold CONTROL LOCK for 3 seconds. The Control Lock light will stay on for a short time,
indicating that it is activated, and all keypads are disabled. If you touch any keypad while your dishwasher is locked,
the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked.
NOTE: You may need to disable Sleep Mode by touching either START/RESUME or CANCEL or by opening and closing
the door before you are able to turn Control Lock off.
To turn off Control Lock, touch and hold CONTROL LOCK for 3 seconds. The light turns off.