Use and Care Manual

6
CONTROL PURPOSE COMMENTS
To start or resume
a wash cycle.
If the door is opened during a cycle or the power is interrupted, the Start/Resume
indicator flashes.
NOTE: Push door firmly closed within 4 seconds of touching Start/Resume. If the door
is not closed within 4 seconds, the Start/Resume keypad LED will flash, an audible tone
will be heard, and the cycle will not start.
To reset any cycle
or options during
selection.
To cancel a wash
cycle after it has
been started.
Touch and hold CANCEL/DRAIN to reset any control selections made. See the
“Dishwasher Feedback” section in the full User Instructions.
To turn the audible
tones on or off.
Touch and hold HI-TEMP WASH for 3 seconds to turn the audible tones on or off. Only
audible tones for confirming keypad touches can be turned on/off. Important audible
tones, such as indicating a cycle has been interrupted, cannot be deactivated.
Sani Rinse indicator If you select the Sani Rinse option, when the cycle is finished, the Sanitized indicator
on the control panel and on the pocket display glows. If your dishwasher did not
properly sanitize your dishes, the Sanitized indicator flashes at the end of the cycle.
This can happen if the cycle is interrupted or if water could not be heated to required
temperature. The light goes off when you open and close door or touch CANCEL.
The Cycle Status
Display estimates
cycle length as you
choose cycles and
options and then
counts down time
to cycle complete.
The Time Display is used for estimated cycle time and also for delay hours.
Estimated cycle time is displayed in hours and minutes as you make cycle and option
selections. After you start the dishwasher, the display counts down the time.
When you select the Delay feature, the time display will give the number of hours
followed by an “H”.
DISHWASHER CARE
Cleaning the Exterior
Clean the exterior of the dishwasher with only a soft, damp cloth
and mild detergent. If your dishwasher has a stainless steel exterior,
it has a coating that is resistant to fingerprints. Avoid using abrasive
cleaning products on the exterior of the dishwasher.
Cleaning and Maintaining the Interior
Many detergents may leave white spots or a white residue on
dishware and on the interior of the dishwasher. Over time this residue
can become unsightly and could affect dishwasher performance.
Use of a dishwasher cleaning product, such as affresh
®
Dishwasher
Cleaner, can help to remove the residue. Monthly use of affresh
®
Dishwasher Cleaner is recommended to help maintain the dishwasher.
Follow package directions.
NOTE: KitchenAid recommends the use of high-quality, premeasured
detergent tablets or packs and the use of rinse aid for dishwasher
cleaning and daily care.
If you have a drain air gap,
check and clean it if the
dishwasher isn’t draining well.
To Reduce Risk of Property
Damage During Vacation or
Extended Time Without Use:
■ When you will not be using
the dishwasher during the
summer months, turn off
the water and power supply
to the dishwasher.
■ Make sure the water supply lines are protected against freezing
conditions. Ice formations in the supply lines can increase
water pressure and cause damage to your dishwasher or home.
Damage from freezing is not covered by the warranty.
■ When storing your dishwasher in the winter, avoid water
damage by having your dishwasher winterized by authorized
service personnel.