Installation guide

9m Check operation of oven
element. Turn oven selector to "BAKE".
"350F" will show on display. Press "Enter".
First Preheat light comes on when oven
temperature begins to rise. When second
Preheat light comes on, open oven door
and hold hand above oven floor and feel
for heat. DO NOT TOUCH OVEN FLOOR.
Press "Cancel" and turn oven selector to
"Reset".
Check the operation of the
broiler element. Turn oven selector to
"BROIL". "HI" will show on display. Press
"Enter". Look through oven window. The
top element should glow red and heat
should be radiating out of the door. Press
"Cancel" and turn oven selector to
"Reset".
If the oven does not operate, check that
power supply is turned on, that no fuses
are blown, or circuit breakers tripped. If
the oven still does not operate, contact
your KitchenAid dealer or designated
service company.
E Reinstall lower vent by
inserting tabs into the slots on the front
trim. Push vent upward until the holes line
up at top of vent. Reattach the vent using
the two screws.
2 m Place burner grates over
burner caps. The simmer plate may set
on one of the grates or be stored for
future use. (See Use and Care Guide.)
Installer checkeff
RANGE
[_ Range correctly positioned in
countertop cutout,
[_ Maintained specified distances to
cabinet surfaces.
Range level - front to back - side to
side.
Burner caps positioned properly on
sealed burner bases.
All packing material removed.
Backguard attached (if horizontal
clearance to combustible materials
behind cooking surface is less than
1" (25A mm).
GAS SUPPLY
[_The range is connected only to type
of gas for which it is certified for use.
If range
dees net eperate:
[_ Check that the circuit breaker is not
tripped or the house fuse blown.
[_] Check that gas valves are turned to
the "ON" position.
[_See Use and Care Guide for
troubleshooting list.
If you need
In the eventthat yourKitchenAidappliance
should needservice, callthe dealerfrom
whom you purchasedthe applianceor a
KitchenAid-designatedservice company.A
KitchenAid-designatedservice companyis
listed inthe YellowPagesof your telephone
directoryunder "Appliances-- Household--
Major-- Serviceand Repair."
Youcan also obtainthe servicecompany's
name and numberby dialing,free withinthe
continentalUnitedStates,the KitchenAid
CustomerInteractionCentertelephone
number,1-800-422-1230.A specialoperator
will tell you the nameof your nearest
KitchenAid-designatedservice company.
Maintainthe quality built into your KitchenAid
appliance-- call a KitchenAid-designated
service company.
if removing the range is necessary for
maintenance, shut off gas supply.
Disconnect the gas and electric supply.
Finish removing the range.
To get the most efficient use
from your new dual fuel range,
read your KitchenAid Use and
Care Guide. Keep Installation
Instructions and Guide close
to the range for easy
reference.
The KitchenAid Customer Interaction
Center will answer any questions about
operating or maintaining your range not
covered in the Installation Instructions.
The KitchenAid Customer Interaction
Center is open 24 hours a day, 7 days a
week. Just dial 1o800o422o1230-- the
call is free within the continental United
States, or visit our web site at
www.kitchenaid,com.
When you call, you will need the range
model number and serial number. Both
numbers can be found on the
model/serial rating plate located on the
surface below the control panel.