Dimension Guide

PRODUCT MODEL NUMBERS
Because Whirlpool Corporation includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Page 1 of 2
Ref. W10896182A
09/21/2016
KDRU767V
KDRU783V
KDRS483V
KDRU763V
KDRS407V
KDRS463V
KDRS467V
30" (76.2 cm), 36" (91.4 cm), and 48" (121.9 cm)
Commercial-Style Dual Fuel Convection Ranges
ELECTRICAL CONNECTION
To properly install your range, you must determine the type of electrical
connection you will be using and follow the instructions provided for it
here.
■ Range must be connected to the proper electrical voltage and
frequency as specified on the model/serial/rating plate. The model/
serial/rating plate is located on the right vertical surface of the oven
door frame. Refer to the illustrations in “Product Dimensions” of the
“Location Requirements” section.
■ This range may be manufactured with a 4-wire power supply cord or
may not include a power supply cord. If your range does not include a
power supply cord, use a 4-wire power supply cord rated at 250 volts,
40 or 50 amps, and investigated for use with ranges
Range Rating*
Specified Rating of Power
Supply Cord Kit and Circuit
Protection
120/240 Volts 120/208 Volts Amps Range Size
8.8–16.5 kW 7.8–12.5 kW 40 or 50** 30" (76.2 cm)
36" (91.4 cm)
16.6–22.5 kW 12.6–18.5 kW 50 48" (121.9 cm)
* The NEC calculated load is less than the total connected load listed
on the model/serial/rating plate.
** If connecting to a 50-amp circuit, use a 50-amp rated cord with kit.
For 50-amp rated cord kits, use kits that specify use with a nominal
13/8" (34.9 mm) diameter connection opening.
■ A circuit breaker is recommended.
■ Wire sizes and connections must conform with the rating of the range.
■ The Tech Sheet is located behind the kick plate in a clear plastic bag.
TYPE OF GAS
Natural Gas:
This range is factory set for use with Natural gas. The model/serial/
rating plate located on the right vertical surface of the oven door frame
has information on the types of gas that can be used. If the types of gas
listed do not include the type of gas available, check with the local gas
supplier.
LP Gas Conversion:
Conversion must be done by a qualified service technician.
No attempt shall be made to convert the range cooktop from the gas
specified on the model/serial/rating plate for use with a different gas
without consulting the serving gas supplier. To convert to LP gas, use
the LP gas conversion kit provided with your range and see the “Gas
Conversions” section. The parts for this kit are in the literature package
supplied with the range.
GAS SUPPLY LINE
■ Provide a gas supply line of
3
/
4
” (1.9 cm) rigid pipe to the range
location. A smaller size pipe on longer runs may result in insufficient
gas supply. With LP gas, piping or tubing size can be
1
/
2
” (1.3 cm)
minimum. Usually, LP gas suppliers determine the size and materials
used in the system.
NOTE: Pipe-joint compounds that resist the action of LP gas must be
used. Do not use TEFLON
®†
tape.
Flexible metal appliance connector:
■ If local codes permit, a new CSA design-certified, 4-5 ft (122-
152.4 cm) long,
5
/
8
" (1.6 cm) or
3
/
4
" (1.9 cm) I.D. flexible metal
appliance connector may be used for connecting range to the gas
supply line.
■ A
1
/
2
" (1.3 cm) male pipe thread is needed for connection to the
female pipe threads of the inlet to the range pressure regulator.
■ Do not kink or damage the flexible metal tubing when moving the
range.
IMPORTANT: All connections must be wrench-tightened. Do not make
connections to the gas regulator too tight. Making the connections too
tight may crack the regulator and cause a gas leak. Do not allow the
regulator to turn or move when tightening fittings.
■ Must include a shut-off valve:
The supply line must be equipped with a manual shut-off valve. This
valve should be located in the same room but external to the range
opening such as an adjacent cabinet. It should be in a location that
allows ease of opening and closing. Do not block access to shut-off
valve. The valve is for turning on or shutting off gas to the range.
A
B
C
A. Gas supply line
B. Shut-off valve “open” position
C. To range
†
®
TEFLON is a registered trademark of Chemours.
30" (76.2 cm) models
D
C
A
B
E
A. Optional backguard may be installed.
B. 27
3
/
4
" (70.5 cm) depth with control panel (See NOTE)
C. 35
3
/
4
" (90.8 cm) cooktop height when sitting on the wheels
D. 30" (76.2 cm) width
E. Model/serial/rating plate location
PRODUCT DIMENSIONS