Setup and user guide

4
Installation
ATTENTION: If the appliance must be moved at any time, keep it in an upright position; if absolutely
necessary, it may be tilted onto its back.
CONNECTING THE WATER SUPPLY
Adaptation of the water supply for installation
should only be performed by a qualified technician.
The water inlet and outlet hoses may be positioned
towards the right or the left in order to achieve the
best possible installation.
Make sure the dishwasher does not bend or squash
the hoses.
CONNECTING THE WATER INLET HOSE
• Run the water until it is perfectly clear.
• Screw the inlet hose tightly into position and turn
on the tap.
If the inlet hose is not long enough, contact a special-
ist store or an authorised technician.
The water pressure must be within the values indicat-
ed in the Technical Data table - otherwise the dish-
washer may be function properly.
Make sure the hose is not bent or compressed.
SPECIFICATIONS FOR THE CONNECTION
OF THE WATER SUPPLY HOSE:
CONNECTING THE WATER OUTLET HOSE
Connect the outlet hose to a drain duct with a mini-
mum diameter of 2 cm A
The outlet hose connection must be at a height rang-
ing from 40 to 80 cm from the floor or surface where
the dishwasher rests.
Before connecting the water outlet hose to the sink
drain, remove the plastic plug B.
ANTI-FLOODING PROTECTION
Anti-flooding protection. To ensure floods do not oc-
cur, the dishwasher:
- is provided with a special system which blocks the
water supply in the event of anomalies or leaks from
inside the appliance.
Some models are also equipped with the supplemen-
tary safety device New Aqua Stop, which guaran-
tees anti-flooding protection even in the event of a
supply hose rupture.
Under no circumstances should the water inlet hose
be cut as it contains live electrical parts.
ELECTRICAL CONNECTION
WARNING: Under no circumstances
should the water inlet hose be cut as it con-
tains live electrical parts.
Before inserting the plug into the electrical socket,
make sure that:
• The socket is earth and complies with cur-
rent regulations;
• The socket can withstand the maximum load of
the appliance as shown on the data plate located
on the inside of the door (see PRODUCT
DESCRIPTION).
• The power supply voltage falls within the values
indicated on the data plate on the inside of the door.
• The socket is compatible with the plug of the
appliance.
If this is not the case, ask an authorised technician to
replace the plug (see AFTER-SALES SERVICE). Do
not use extension cables or multiple sockets. Once the
appliance has been installed, the power supply cable
and the electrical socket should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, have it re-
placed by the manufacturer or its authorised Techni-
cal Assistance Service in order to prevent all
potential hazards.
The Company shall not be held responsible for any
incidents, if these regulations are not observed.
Before using the appliance carefully read Health and Safety guide.
WATER SUPPLY cold or hot (max. 60°C)
WATER INTAKE 3/4”
POWER OF WATER
PRESSURE
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
7,25 – 145 psi
MIN 40 cm
MAX 80 cm