Setup and user guide

18
PROBLEMS POSSIBLE CAUSES SOLUTIONS
The dishes are
not clean.
The crockery has not been arranged
properly.
Arrange the crockery correctly
(see LOADING THE RACKS).
The spray arms cannot rotate freely,
being hindered by the dishes.
Arrange the crockery correctly
(see LOADING THE RACKS).
The wash cycle is too gentle and/or
detergent efficiency is low.
Select an appropriate wash cycle (see PROGRAMS
TABLE).
An excessive amount of foam has been
produced.(see AFTER-SALES SER-
VICE)
The detergent has not been measured out correctly or
it is not suitable for use in dishwashers (see FILLING
THE DETERGENT DISPENSER).
Reset dishwasher by pressing the DRAIN button (see
OPTIONS AND FUNCTIONS) and run new program
without detergent.
The cap on the rinse aid compartment
has not been shut correctly.
Make sure the cap of the rinse aid dispenser is closed.
The filter is soiled or clogged.
Clean the filter assembly
(see Care and maintenance).
There is no salt.
Fill the salt reservoir (see FILLING THE SALT RES-
ERVOIR).
The dish-
washer does
not fill the
water.
No water in the water supply or the tap
is closed.
Make sure there is water in the water supply or the tap
running.
The inlet hose is bent.
Make sure the drain hose is not bent (see INSTALLA-
TION) reprogram the dishwasher and reboot.
The sieve in the water inlet hose is
clogged; it is necessary to clean it
After having carried out the verification and cleaning,
turn off and turn on the dishwasher and restart a new
program.
The dishes and
glasses show
calcination or
a whitish film.
The salt level is too low.
Fill the salt reservoir (see FILLING THE SALT RES-
ERVOIR).
The adjustment of the water hardness is
not adequate.
Increase the values (see Water Hardness Table).
The cap of the salt reservoir is not prop-
erly closed.
Check to have properly closed the salt reservoir cap.
The rinse aid is used up or the dosage is
insufficient.
Add the rinse aid or adjust the dosage levels higher.
The dishes and
glasses are
blue streaked
or have a blu-
ish tinge.
The rinse aid dosage is excessive. Adjust the dosage rates below.